Connections
•Phones and Line Out Terminals
Before connecting phones or other external equipment, be sure to first turn down the volume settings of the keyboard and the connected equipment. You can then adjust volume to the desired level after connections are complete.
[Front]
PHONES Terminal
1
Stereo standard plug
Connecting Phones (Figure 1)
Connecting phones cuts off output from the keyboard’s
[Rear Panel]
2 Audio amplifier AUX IN, etc. | PIN plug |
| |
LEFT |
|
(White) |
|
RIGHT |
|
(Red) |
|
| MIDI |
|
|
| SUSTAIN/ | R L/MONO |
|
OUT | IN ASSIGNABLE JACK | LINE OUT | DC 12V |
3 Guitar amplifier, | Standard jacks |
|
|
|
|
| |
keyboard amplifier, etc. |
|
|
|
Standard plugs
INPUT 1 
INPUT 2
Connecting to Audio Equipment 2
Use commercially available cords to connect to the two jacks as shown in Figure 2. It is up to you to purchase connecting cables like the ones shown in the illustration for connection. Normally in this configuration, you must set the audio equipment’s input selector to the setting that specifies the terminal (such as AUX IN) that the keyboard is connected to. Use the keyboard’s VOLUME slider to adjust the volume level.
Connecting to a Musical Instrument Amplifier 3
Use commercially available cords to connect to the two jacks as shown in Figure 3. It is up to you to purchase connecting cables like the ones shown in the illustration for connection. Use the keyboard’s VOLUME slider to adjust the volume level.
•If your amplifier has only one input jack, use an adapter like the one shown below.
Standard plug
Standard jack
❚ NOTE ❚
You can also connect the keyboard’s MIDI terminal to a computer or se-
quencer. See “MIDI” on page
Phones/Output Terminal
Before connecting phones or other external equipment, be sure to first turn down the volume settings of the keyboard and the connected equipment. You can then adjust volume to the desired level after connections are complete.
[Front]
PHONES/OUTPUT Terminal
1
Stereo standard plug
3
Keyboard amp, |
|
| Red PIN plug |
guitar amp, etc. | 2 | White | |
|
| LEFT | RIGHT |
|
| AUX IN or similar terminal | |
|
| of audio amplifier | |
Connecting Phones (Figure 1)
Connecting phones cuts off output from the keyboard’s
Audio Equipment (Figure 2)
Connect the keyboard to a audio equipment using a commercially available connecting cord with a standard plug on one end and two PIN plugs on the other end. Note that the standard plug you connect to the keyboard must be a stereo plug, otherwise you will be able to output only one of stereo channels. In this configuration, you normally set the input selector of the audio equipment to the terminal (usually marked AUX IN or something similar) where the cord from the keyboard is connected. See the user documentation that comes with your audio equipment for full details.
Musical Instrument Amplifier (Figure 3)
Use a commercially available connecting cord to connect the keyboard to a musical instrument amplifier.
❚ NOTE ❚
Be sure to use a connecting cord that has a stereo standard plug on the end you connect to the keyboard, and a connector that provides dual channel (left and right) input to the amplifier to which you are connecting. The wrong type of connector at either end can cause one of the stereo channels to be lost.
When connected to a musical instrument amplifier, set the volume of the keyboard to a relatively low level and make output volume adjustments using the amplifier’s controls.
Page 12 | 03.7.31, 5:20 PM Adobe PageMaker 6.5J/PPC |