Projecting the Screen Image of a

Graphing Calculator

You can connect a CASIO graphing calculator to the Data Projector using a USB cable and project the calculator’s screen image with the Data Projector. USB connection of the following CASIO graphing calculators is supported.

fx-9860G Series

To project the screen image of a graphing calculator

1. Set the graphing calculator up for data communication.

Enter the LINK Mode, and configure the “Wakeup” and “Capture” settings as shown below.

Be sure to configure these communication settings before you connect the calculator to the Data Projector.

See the user documentation that comes with your calculator for details about configuring these settings.

2.Turn on the Data Projector.

3.Use the USB cable that came with the graphing calculator to connect it to the Data Projector as illustrated below.

This will project an image of the graphing calculator from the Data Projector.

USB Cable

*The illustration shows the fx-9860G as an example.

Important!

If an hourglass figure appears in the image projected from the Data Projector when you connect the calculator, perform some operation on the calculator. This should cause the hourglass to disappear and enable normal projection.

If the calculator does not operate properly after you connect it to the Data Projector, try disconnecting the USB cable from the calculator and then reconnecting it. If this does not correct the problem, disconnect the USB cable from both the Data Projector and the calculator. Turn the Data Projector off and then back on again, and then re-connect the calculator.

50