7
8
9
Enter a key sequence up to eight key operations long.
zYou can use any of the following keys as part of your password key sequence.
[INPUT], [AUTO], [BLANK], [FREEZE], [COLOR MODE],
], [U], [
], [S], [T], [W], [X], [FUNC]
After entering the new password, press the [ENTER] key.
zThis will display a dialog box prompting you to enter the same password again.
zThe message “Your new password has been registered.” indicates that the password has been changed. Press the [ESC] key.
zIf the password you entered in this step is different from the one you entered in step 7, the message “The password you input is wrong.” appears. Press the [ESC] key to return to step 7.
10 After you are finished, press the [MENU] key to exit the setup menu.
To turn password protection on and off
1 Display the Power On Password setting screen by performing steps 1 through 5 of the procedure under “To change the password” on page 14.
zAt this time, make sure that “Power On Password” is selected on the Power On Password setting screen.
2 Use the [W] and [X] keys to select “On” or “Off”.
z Changing the power on password setting from “On” to “Off” causes the confirmation dialog box shown below to appear.
Press the [ENTER] key to confirm that you want to turn on power on password protection, or [ESC] to exit the dialog box without doing anything.
3 After you are finished, press the [MENU] key to exit the setup menu.
Entering the Password when Turning On the Projector
When you turn on the projector while password protection is turned on will cause a password input dialog box to appear on the projection screen. All projector operations will be accessible to you after you input the correct password and press the [ENTER] key.
Note
You can perform the projection size adjustment operation ([ZOOM +] / [ZOOM 
] key) while the password input dialog box is on the projection screen.
15