FASTENING THE
APPLIANCE
Each ceramic griddle is supplied with a set of tabs and screws fasten it on units.
✓Cut the unit (as shown in figure 3).
✓Stretch gasket “D” over the edge of the hole made, being careful to overlay the junction edges.
✓Turn the ceramic griddle over and put tabs “A” into the mountings, only tighten screws “B” a few turns (fig. 6).
Make sure that the tabs are mounted correctly as shown in the figures. Turn the tabs so that the cooktop can be put into the hole.
✓Put the cooktop into the hole cut into the unit and position it correctly.
✓Put tabs “A”; into place, tooth “C” of the tabs should go into the hole (fig. 6).
✓Tighten screws “B” until the cooktop is completely secured.
✓Using a sharp tool cut off the part of gasket “D” which protrudes from the cooktop.
Figure 5
A |
A |
A |
A |
Figure 6
|
| D |
|
C |
|
|
|
B | A | 30 mm min. | 40 mm max. |
|
|
9