How to Install the Hob

How to install the hob:

Overall dimensions of the hob: HVC60 Width 590mm Depth 510mm

HVC70 Width 770mm Depth 510mm

HVC90 Width 900mm Depth 510mm

Worktop cut-out dimensions: HVC60 Width 560mm Depth 490mm

HVC70 Width 740mm Depth 490mm

HVC90 Width 870mm Depth 490mm

1.Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker hood to ensure that you will have the required clearance. The cut-out (Fig.12) shows a 60mm gap from the wall to the cut-out edge. The distance from the hob, when fitted, to the back wall is 50mm. If a splashback/worktop upstand is to be fitted, take this into account when cutting the hole. The minimum distance that the hob should be positioned away from the rear wall or splashback is 50mm.

2.Position the hob seal, as shown in (Fig.14), ensuring that the ends meet without overlapping. Do not use silicone type sealant.

3.Secure the hob to the worktop using the fixing brackets and screws supplied, as shown in (Fig.15). Remove any excess sealant after tightening the brackets. Do not over-tighten the fixing brackets.

 

60mm

 

 

490mm

650mm

 

400mm

 

560mm

 

 

740mm

 

190mm

870mm

 

190mm

 

Fig.12

Fig.13

 

 

3cm

4cm

 

 

Fig.14

Fig.15

 

10

Page 11
Image 11
CDA HVC90, HVC70, HVC60 manual How to Install the Hob, How to install the hob