Care and Maintenance
Always disconnect the appliance from the power supply before undertaking any cleaning or maintenance.
You should use a
Do not use steel wool, abrasive sponges or sharp utensils such as knives to clean the hob as these could damage the hob. The hob surface and the pans must be clean.
Carefully remove any food remains (especially those containing sugar), dirt etc. as soon as is possible after spillage - using a ceramic hob scraper if necessary whilst the zone is still hot.
Once they have cooled and hardened they become increasingly difficult to remove.
Sugar, syrup and starch mixtures could permanently pit the hob surface if left to burn on and should be removed as quickly as possible after spillage.
The stainless steel trims should be rinsed with water and dried with a soft, clean cloth, a chamois leather or an
If necessary, the control knobs can be removed for cleaning, but you should take care not to damage the seal nor to allow water inside the hob itself.
All cleaner residues should be removed with a damp cloth.
Types of residues | Clean with | Cleaning advice | |
|
|
| |
Light | Cleaning sponge and soft cloth | Wipe over the zone to be cleaned with a sponge and hot | |
water, and then wipe off with a soft dry cloth. | |||
|
| ||
|
|
| |
Accumulated | Cleaning sponge or glass scraper | Wipe over the zone to be cleaned with a sponge and hot | |
water, using a ceramic scraper to remove any large marks | |||
dirt, sugar spills or melted plastics | and soft cloth | ||
or stains and then wipe off with a soft dry cloth. | |||
|
| ||
|
|
| |
Rings and hard water residues | White vinegar and soft cloth | Pour a small amount of warm white vinegar onto the stain, | |
leave it to stand, and then wipe off with a soft dry cloth. | |||
|
| ||
|
|
|
Important:
•Steam cleaners must not be used when cleaning this appliance.
Mains electrical voltage: | 230 – 240Vac | |
Total rated electrical consumption: | HVC60 | 6.9 kW |
| HVC70 | 6.8 kW |
| HVC90 | 8.6 kW |
If your Hob is not working:
1.Check that the control knobs are switched on.
2.Check that the mains supply has not been switched off.
3.Check that the fuse in the spur has not blown.
Contact CDA Customer Care
A : Customer Care Department, The CDA Group Ltd, Harby Road, Langar, Nottinghamshire, NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
7
