11
Power Ignition and Adjustment of a Cooking Zone
To turn ON a cooking zone the touch control must be switched ON (see section “How To Turn the Touch Control ON and OFF”).
Press the key |
|
|
| and keep it pressed until the desired power | |||||||
level, ranging |
| between 1 and 9 is set. |
|
|
|
|
| ||||
As an alternative, press the key | . The choice starts from | ||||||||||
level 9 (maximum level) down to 1 (minimum level). | |||||||||||
To reset the power level press the key | and keep it pressed | ||||||||||
until power level zero ( 0 ) or alternatively press the keys |
|
|
|
| |||||||
and | at the same time. |
|
|
|
|
|
| ||||
Functioning of the Double Cooking Zone
The double cooking zone consists of two circuits, which may be used in the following modes:
–Reduced cooking zone: only the first heating unit is switched ON.
–Extended cooking zone: the first and second heating circuits are both switched ON.
Turn on the cooking zone as described in the section: "Power Ignition and Adjustment of a Cooking Zone"; only the first heating unit will switch on.
Press the key 
to operate also the second heating circuit (the indicator light close to the key will light up), then set the desired power level by using the keys 
and .
To turn off the second heating circuit press the key 
(the indicator light close to the key will go out).
Afterheat in Cooking Zone/s
When switching off a cooking zone (power level 0 ), if the temperature of the zone is too warm to be touched the display will show alternately " H " and " 0 ".
Whenever the touch control is switched off, the residual heat is shown by a static " H ".
"H " is turned OFF when the cooking zone temperature drops below 65 °C.
