HARDWARE PACK
H E A V Y A R T I C L E N E E D S 2 T O L I F T
THIS MANUAL MUST REMAIN WITH THE PRODUCT AT ALL TIMES
To ORDER
TOOLS NEEDED FOR ASSEMBLY
•#2 Phillips screwdriver (Long and short)
•¼” Slotted screwdriver (Long and short)
•Adjustable wrench
•Pliers
•Rubber Mallot
Before assembling the barbecue, read these instructions carefully.
Assemble the barbecue on a fl at, clean surface. Grill is heavy.
Notes: Do not fully tighten all the nuts during this initial stage.
No. | Description | Part Number | Quantity |
1 | 8 | ||
2 | 4 | ||
3 | 8 | ||
4 | ø7 Lock Washer | 20 | |
5 | ø7 Washer | 20 | |
6 | 24 | ||
7 | ø 5 Lock Washer | 24 | |
8 | ø 5 Washer | 24 | |
9 | ST4.2x10 Tapping Screw | 4 | |
10 | Wrench | 1 | |
11 | 4 | ||
12 | Control Knob | 1 | |
13 | Wing Nut | 1 |
please visit us on the web at
www.centrobbqs.com.
Caution:
Sheet metal can cause injury. Wear gloves when installing the grill.
CAUTION
Sharp edges. Wear gloves when assembling your grill.
CAUTION
Read and follow all safety statements, assembly instructions, and use and care directions before attempting to assemble and cook.
INSTALLERORASSEMBLER/CONSUMER
This manual should be kept with the BBQ at all times.
WARNING
Failure to follow all of the Manufacturer’s instructions could result in hazardous fires, explosions, property damage, or serious personal injury or even death.
Follow all leak check procedures carefully prior to operation of barbecue, even if grill was dealer assembled. Do not try to light this barbecue without reading the Lighting Instructions section of this manual.
DANGER
1.If you smell Gas:
a.Shut off gas to the appliance
b.Extinguish any open flame
c.Open lid
d.If odor continues, keep away from the appliance and immediately call your gas supplier or your fire department
2.Do not store or use gasoline or other flammable vapours and liquids in the vicinity of this or any other appliance.
3.An LP cylinder not connected for use shall not be stored in the vicinity of this or any other appliance.
4.Requires two people to complete the assembly process.
5.Beware of sharp edges.
1
¼” - 20UNCX13 Screw
X 8
4
ø7 Lock Washer
X 20
7
ø5 Lock Washer
X 24
10
Wrench
X 1
2 | 3 |
¼” - 20UNCX38 Screw | ¼” - 20UNCX16 Screw |
X 4 | X 8 |
5 | 6 |
ø7 Washer | NO. |
X 20 | X 24 |
8 | 9 |
ø5 Washer | ST4.2x10 Tapping Screw |
X 24 | X 4 |
11 | 12 |
NO. | Knob |
X 4 | X 1 |
T H I S B A R B E C U E I S F O R O U T D O O R U S E O N LY
CONTACT CALL CENTRE IF ANY PARTS ARE MISSING
13
Wing Nut
X 1
1
