SETUP
Mode Select
Stereo Mode
In stereo mode, both channels operate independently with individ- ual input gain controls. Signal at channel 1’s input produces output at channel 1, while signal at channel 2’s input produces output at channel 2’s output. Recommended minimum nominal load imped- ance for stereo operation is 2 ohms per channel.
Parallel Mode
When set to Parallel mode, a signal applied to channel 1’s input will be amplified and appear at outputs for both channel 1 & 2. The parallel mode is well suited for applications in which driving two speakers with the same signal but with separate amplification. The ‘Channel1’ and ‘Channle 2’ input gain controls individually control the out put level on channels 1 and 2.
Bridged Mono Mode
Bridged mono mode straps both amplifier channels together to make a very powerful,
Signal is applied to the channel 1 input only and channel 1 input gain control is used to adjust signal level. The input gain control be- longing to channel 2 are not used.
Note : Bridged mono mode is to be used only when the
iting.
Use extreme caution when operating the amplifier in Bridged Mono Mode. Never ground either side of the speaker cable; the speaker load must “ float “ away from the am-
plifier chassis.
CONNECTIONS
Stereo Mode
Parallel Mode
Bridged Mono Mode
7