CERWIN-VEGA! PROFESSIONAL ACTIVE SERIES
4
A) Power Indicator: Illuminates when the system is powered
on.
B) Limit Indicator: Illuminates when the protection limiter is
active.
C) Protect Indicator: Illuminates when the amp has shut
down to protect its self.
D) Signal Indicator: An audio signal is present at the input.
E) Power, On/Off: Switches system on and off.
F) Voltage Switch: Allows system to be used with
supply voltages of either 110-120 volts or 220- 240 volts.
Warning: Do not plug system into a 220-240
volt circuit while switch is in the 110-120 volt
position. Be sure to use the correct value and
rating fuse for the voltage selected!
G) AC Output: Intended to run power to one or two
additional CVA-28 units. NEVER daisy chain more than
three CVA-28’s from a single source!
H) AC Input: Input for attachment of an IEC power cord
I) FUSE: Be sure to use the correct value and rating
fuse for the voltage selected!
J) Level Control: Adjusts the input signal to the amplifi er.
K) Line/Mic: Balanced and unbalanced signals are
suppor ted on both the XLR input connector and the
quarter inch input connector. Allows input to accept
either a line level or a mic level signal. Mic/DI is for a
microphone or instrument direct input. Line is for a line
level output from an audio source such as a mixing board
L) No Sub/Sub: Use the “No Sub” position when a
dedicated subwoofer is not being used. This position
provides more bass for full range use. Use the “Sub”
position when a dedicated subwoofer is used. This
position reduces some low frequency information that
may interfere with your subwoofer frequencies creating a
“muddier” or less-defi ned sound. Experiment with this
control for the best results. Removal of these bass
frequencies also allows the CVA-28 to play louder.
M) Off/Contour: Provides an alternate internal equalizition
circuit that reduces mid range. Setting this switch to the
On position when playing the CVA-28 at high volumes
will reduce mid range frequencies for a more even
response.
N) THRU: This THRU signal bypasses the controls and is a
buffered output of the IN signal. Allows the signal at IN
to be routed to another CVA-28. Note that you must set
up the controls on each CVA-28 independently.
O) IN: Balanced XLR and 1/4 inch TRS connectors accept
signals from balanced or unbalanced line level or Mic
level sources. Signal at IN is bufferred and routed to
Thru.
BACK PANEL CONTROLS, CONNECTORS AND INDICATORSA
BCD
E
F
G
H
I
J
N
OK L M
MANUAL_CVA28manual20-7.indd 5MANUAL_CVA28manual20-7.indd 5 8/9/07 12:00:49 PM8/9/07 12:00:49 PM