PROGRAMMING

Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will open and close when you press the large push button.

Below are instructions for programming your opener to operate with additional Security✚ remote controls.

To Add an Additional Hand-held Remote Control

USING THE “LEARN” BUTTON

USING THE MULTI-FUNCTION DOOR CONTROL

1

2

3

12

1

2

 

1. Press and release the “learn”

 

1. Press and hold the button on the

button on the motor unit. The

 

hand-held remote* that you wish

learn indicator light will glow

KG

to operate your garage door.

steadily for 30 seconds.

 

 

 

 

2. While holding the remote button,

 

 

press and hold the LIGHT button

2. Within 30 seconds, press and

 

on the Multi-Function Door

 

Control.

hold the button on the hand-held

 

remote* that you wish to operate

 

 

your garage door.

 

3. Continue holding both buttons

 

 

 

 

while you press the push bar on

 

 

the Multi-Function Door Control

3. Release the button when the

 

(all three buttons are held).

 

 

motor unit lights blink. It has

 

 

learned the code. If light bulbs are

 

 

not installed, two clicks will be

 

4. Release buttons when the motor

heard.

 

 

unit lights blink. It has learned the

 

 

 

 

code. If light bulbs are not

 

 

installed, two clicks will be heard.

LOCK

LIGHT

LOCK

LIGHT

LOCK

LIGHT

To Erase All Codes From Motor

Unit Memory

12

To deactivate any unwanted remote, first erase all codes:

Press and the hold “learn” button on

KG

motor unit until the learn indicator light goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use.

*3-Channel Remotes

If supplied with your garage door opener, the large button is factory programmed to operate it. Additional buttons on any

Security✚ 3-channel remote or mini-remote can be programmed to

operate other

Security✚ garage door openers.

31