Installation Step 12

Fasten Door Bracket

Follow instructions which apply to your door type as illustrated below or on page 21.

To pre vent dama g e to steel, alumin um, fiber glass or glass panel door s, al ways reinf orce the inside of the door both ver ticall y and horizontall y with an angle ir on.

A horizontal brace should be long enough to be secured to 2 vertical supports. A vertical brace should cover the height of the top panel.

The illustration shows one piece of angle iron as the horizontal brace. For the vertical brace, 2 pieces of angle iron are used to create a U-shaped support. The best solution is to check with your garage door manufacturer for an opener installation door reinforcement kit.

SECTIONAL Door Installation Procedure

•Center the door bracket on the previously marked vertical guideline used for the header bracket installation. Note the correct UP placement, as stamped inside the bracket.

•Position the bracket on the face of the door within the following limits:

A)The top edge of the bracket 2-4" below the top edge of the door.

B)The top edge of the bracket directly below any structural support across the top of the door.

•Mark and drill 5/16" left and right fastening holes. Secure the bracket as shown in Figure 1 if there is vertical reinforcement.

If your installation doesn't require vertical reinforcement but does need top and bottom fastening holes for the door bracket, fasten as shown in Figure 2.

Figure 1

Figure 2

Hardware Shown Actual Size

20