Operation of Your Opener

Activate the opener with any of the following:

•The Remote Control Transmitter. Hold push button down until the door starts to move.

•The Door Control. Hold push bar or button down until the door starts to move.

•The Outside Keylock or Keyless Entry. (See Accessories)

When the opener is activated with the safety reversing sensor installed and correctly aligned:

WARNING

Weak or broken springs could allow an open door to fall (either rapidly or unexpectedly), resulting in serious injury, death or property damage. If possible, use the manual release rope and handle only when the door is fully closed.

1.If open, the door will close. If closed, the door will open.

2.If closing, the door will reverse.

3.If opening, the door will stop (allowing space for entry and exit of pets and for fresh air).

4.If the door has been stopped in a partially open position, it will close.

5.If obstructed while closing, the door will reverse.

6.If obstructed while opening, the door will stop.

7.The garage door will reverse in the closing cycle when the invisible beam is broken. If fully open, the door will not close when the beam is broken. The sensor has no effect in the opening cycle.

If the sensor is not installed, or is not aligned correctly, the door won't close from any remote transmitter. You can close the door with the Door Control, the Outside

Trolley

Trolley

ReleaseArm

(in Manual

Disconnect

Position)

NOTICE

Lockout position(Manual disconnect)
To open the door manually:

The door should be fully closed if possible. Pull down on the manual release handle (so that the trolley release arm snaps into a vertical position) and lift the door manually. The lockout feature prevents the trolley from reconnecting auto- matically, and the door can be raised and lowered manually as often as necessary.

Keylock, or Keyless Entry, however, if you activate them until down travel is complete. If you release them too soon, the door will reverse.

The opener lights will blink for 5 seconds when the safety reversing sensor causes the door to reverse.

Opener Lights will turn on under the following conditions: When the opener is initially plugged in; when the power is interrupted; when the opener is activated. They will turn off automatically after 4-1/2 minutes or provide constant light when the Light feature is activated. Bulb size is 100 watts maximum.

To reengage the trolley: Pull the manual release handle toward the opener at a 45° degree angle so that the trolley release arm is horizontal. The trolley will reconnect on the next UP or DOWN operation, either manually or by pressing the Door Control push bar.

Trolley

 

Trolley

 

Release Arm

Manual

 

Release

NOTICE

Handle

 

(Pull at 45° angle)

To reconnect
Operation of the Door Controls (both are not included with all models)
Lighted Door Control Button;Lock Feature – Door Control Panel: The Lock
Lighted Push Bar – Door Control Panel: Press to

feature is designed to prevent operation of the door from

open or close the door.

remote controls. However, the door will open and close

Press again to reverse the door during the closing cycle

from the Door Control push bar, the Outside Keylock

and the Keyless Entry Accessories.

or to stop the door while it's opening.

To Activate: Press and hold the Lock button for

Light Feature – Door Control Panel: Press the Light

2 seconds. The push bar light will flash as long as the

button. If the opener light is off, it will turn on.

Lock feature is on.

If the opener light is on, (even in the 4-1/2 minute

To turn off: Press and hold the Lock button again for

automatic cycle) it will turn off.

2 seconds. The push bar light will stop flashing. The

But if you use the Light button to turn the light(s) on and

Lock feature will also turn off whenever the "Smart"

then activate the opener, the light(s) will turn off after

button on the opener panel is activated.

4-1/2 minutes.

 

The Light button will not control the opener lights when

 

the door is in motion.

 

28