INSTALLATION STEP 11

Fasten the Door Bracket

Follow instructions which apply to your door type as illustrated below or on the following page.

A horizontal reinforcement brace should be long enough to be secured to two or three vertical supports. A vertical reinforcement brace should cover the height of the top panel.

Figure 1 shows one piece of angle iron as the horizontal brace. For the vertical brace, 2 pieces of angle iron are used to create a U-shaped support. The best solution is to check with your garage door manufacturer for an opener installation door reinforcement kit.

NOTE: Many door reinforcement kits provide for direct attachment of the clevis pin and door arm. In this case you will not need the door bracket; proceed to Step 12.

SECTIONAL DOORS

1.Center the door bracket on the previously marked vertical centerline used for the header bracket installation. Note correct UP placement, as stamped inside the bracket.

2.Position the top edge of the bracket 2"-4" below the top edge of the door, OR directly below any structural support across the top of the door.

3.Mark, drill holes and install as follows, depending on your doorís construction:

Metal or light weight doors using a vertical angle iron brace between the door panel support and the door bracket:

ïDrill 3/16" fastening holes. Secure the door bracket using the two 1/4"-14x5/8" self-threading screws. (Figure 2A)

ïAlternately, use two 5/16" bolts, lock washers and nuts (not provided). (Figure 2B)

Metal, insulated or light weight factory reinforced doors:

ïDrill 3/16" fastening holes. Secure the door bracket using the self-threading screws (Figure 3).

Wood Doors:

ïUse top and bottom or side to side door bracket holes. Drill 5/16" holes through the door and secure bracket with 5/16"x2" carriage bolts, lock washers and nuts (not provided). (Figure 4)

CAUTION

To prevent damage to garage door, reinforce inside of door with angle iron both vertically and horizontally.

Header

Bracket

Door

 

 

Bracket

 

 

Location

 

 

 

HORIZONTAL AND VERTICAL

 

REINFORCEMENT IS NEEDED

Vertical

FOR LIGHTWEIGHT GARAGE

Centerline

DOORS (FIBERGLASS,

of Garage

ALUMINUM, STEEL, DOORS

Door

WITH GLASS PANEL, ETC.).

 

(NOT PROVIDED)

Figure 1

 

 

 

Vertical

 

(Not Provided) Reinforcement

Vertical

 

Vertical

Reinforcement

 

Centerline

 

 

of Garage Door

Vertical

Bolt

 

Centerline

 

5/16"-18x2"

 

of Garage Door

 

 

 

 

 

UP

 

Door

 

UP

Bracket

 

 

 

Door

Lock Washer

5/16"

Nut

Bracket

 

 

5/16"-18

Self-Threading

 

 

Figure 2B

Screw

 

1/4"-14x5/8"

 

 

Figure 2A

 

 

 

(Not Provided)

Inside Edge

 

of Door or

 

 

 

 

Reinforcement Board

 

Bolt

 

 

5/16"x2"

 

 

 

UP

Vertical

 

 

Centerline

 

 

of Garage Door

 

 

Vertical

 

UP

Centerline

 

 

of Garage

 

 

Door

 

NOTE: The 1/4"-14x5/8" self-threading screws are not intended for use on wood doors.

HARDWARE

SHOWN

ACTUAL SIZE

Self-Threading Screw 1/4"-14x5/8"

 

 

 

Self-Threading

Figure 4

Screw

 

1/4"-14x5/8"

 

 

 

 

Figure 3

20