OPERATION
IMPORTANT SAFETY INSTRUCTIONS
W ARN ING
To reduce the risk of severe injury or death:
1.READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS.
2.ALWAYS keep remote controls out of reach of children. NEVER permit children to operate or play with garage door control push buttons or remote controls.
3.ONLY activate garage door when it can be seen clearly, it is properly adjusted, and there are no obstructions to door travel.
4.ALWAYS keep garage door in sight until completely closed. NO ONE SHOULD CROSS THE PATH OF THE MOVING DOOR.
5.If possible, use emergency release handle to disengage trolley ONLY when garage door is CLOSED. Weak or broken springs or unbalanced door could result in an open door falling rapidly and/or unexpectedly.
6.NEVER use emergency release handle unless garage doorway is clear of persons and obstructions.
7.NEVER use handle to pull garage door open or closed. If rope knot becomes untied, you could fall.
8.If one control (force or travel limits) is adjusted, the other control may also need adjustment.
9.After any adjustments are made, the safety reversal system MUST be tested.
10.Safety reversal system MUST be tested every month. Garage door MUST reverse on contact with
11.ALWAYS KEEP GARAGE DOOR PROPERLY BALANCED (see page 3). An improperly balanced door may not reverse when required and could result in severe injury or death.
12.All repairs to cables, spring assemblies and other hardware, all of which are under EXTREME tension, MUST be made by a trained door systems technician.
13.ALWAYS disconnect electric power to garage door opener before making any repairs or removing covers.
14.SAVE THESE INSTRUCTIONS.
Using Your Garage Door Opener
Your Security | ✚ opener and |
| ||
have been |
| |||
changes with each use, randomly accessing over |
| |||
100 billion new codes. Your opener will operate with |
| |||
up to eight Security | ✚ remote controls and one |
| ||
Security ✚ Keyless Entry System. If you purchase a |
| |||
new remote, or if you wish to deactivate any remote, |
| |||
follow the instructions in the | Programming | section. | ||
Activate your opener with any of the following:
• | The | Hold the large |
| push button down until the door starts to move. | |
• | The | Hold the push |
| button or bar down until the door starts to move. | |
• | The Keyless Entry (See Accessories): | If provided |
| with your garage door opener, it must be |
|
| programmed before use. See | Programming. |
When the opener is activated (with the safety reversing sensor correctly installed and aligned)
1.If open, the door will close. If closed, it will open.
2.If closing, the door will reverse.
3.If opening, the door will stop.
4.If the door has been stopped in a partially open position, it will close.
5.If obstructed while closing, the door will reverse. If the obstruction interrupts the sensor beam, the opener lights will blink for five seconds.
6.If obstructed while opening, the door will stop.
7.If fully open, the door will not close when the beam is broken. The sensor has no effect in the opening cycle.
If the sensor is not installed, or is misaligned, the
door won't close from a |
| |
you can close the door with the Door Control, the |
| |
Outside Keylock, or Keyless Entry, | if you activate | |
them until down travel is complete. | If you release | |
them too soon, the door will reverse. |
| |
The opener lights | will turn on under the following | |
conditions: when the opener is initially plugged in; when power is restored after interruption; when the opener is activated.
They will turn off automatically after
Security ✚ light feature: Lights will also turn on
when someone walks through the open garage door. With a
be turned off as follows: With the opener lights off, press and hold the light button for 10 seconds, until the light goes on, then off again. To restore this feature, start with the opener lights on, then press and hold the light button for 10 seconds until the light goes off, then on again.
27