Using the Wall-Mounted Door Control
Additional feature when used with the
To control the opener lights:
THE PASSIVE INFRARED CONTROL CONSOLE
Press the push bar to open or close the door. Press again to reverse the door during the closing cycle or to stop the door while it's opening.
This door control contains a motion detector that will automatically turn on the light when it detects a person entering the garage. This feature can be
easily turned off for extended work light use.
Push
Bar
Detector
Switch
LO C K
LIG H T
Lock
Button Light
Button
In addition to operating the door, you may program the remote to operate
the lights.
1.With the door closed, press and hold a small remote button that you want to control the light.
2.Press and hold the Light button on the door control.
3.While holding the Light button, press and hold the Lock button on the door control.
4.After the opener lights flash, release all buttons.
Light feature
Press the Light button to turn the opener light on or off. It will not control the opener lights when the door is in motion. If you turn it on and then activate the opener, the light will remain on for
a
When using the opener lights as working lights, we recommend that you first disable the motion sensor
To Open the Door Manually
W ARN ING
•To prevent possible SERIOUSLY INJURED or KILLED from a falling garage door:
–If possible, use emergency release handle to disengage trolley ONLY when garage door is CLOSED. Weak or broken springs or unbalanced door could result in an open door falling rapidly and/or unexpectedly.
–NEVER use emergency release handle unless garage doorway is clear of persons and obstructions.
•NEVER use handle to pull door open or closed. If rope knot becomes untied, you could fall.
See Automatic Light Feature, | following. |
Automatic Light Feature: | The opener light will |
turn on automatically when a person enters the garage. When a person walks in front of the door control, the light will come on for five minutes, then shut off. This feature works by detecting body heat and may not work in temperatures around 100˚F.
To disable this feature, slide the Detector Switch on the right side of the door control down (off).
We recommend that you disable the motion sensor when using the opener lights as working lights. Otherwise, they will turn off automatically if you are working beyond the sensor’s range.
Lock feature
Designed to prevent operation of the door from hand- held remote controls. However, the door will open
and close from the Door Control, the Outside Keylock and the Keyless Entry Accessories.
To activate, press and hold the Lock button for 2 seconds. The push bar light will flash as long as the Lock feature is on.
To turn off, press and hold the Lock button again for
2 seconds.The push bar light will stop flashing. The Lock feature will also turn off whenever the “Smart” (learn) button on the motor unit panel is activated.
The door should be fully closed if possible. Pull down on the emergency release handle and lift the door manually. To reconnect the door to the opener, press the door control push bar.
The lockout feature | prevents |
the trolley from reconnecting |
|
automatically. Pull the |
|
emergency release handle |
|
down and back (toward the |
|
opener). The door can then |
|
be raised and lowered |
|
manually as often as |
|
necessary. To disengage the |
|
lockout feature, pull the |
|
handle straight down. The |
|
trolley will reconnect on the |
|
next UP or DOWN operation. |
|
| Trolley |
Emergency | Release |
Arm |
Release |
|
Handle | N |
| |
(Pull Down) | O T |
IC E | |
| |
MANUAL DISCONNECT |
|
POSITION |
|
| Trolley |
| Release |
| Arm |
Emergency |
|
Release Handle |
|
(Pull Down & Back |
|
Towards Opener) | N O TIC |
| E |
LOCKOUT POSITION
28