MAIN MENU

RS-232/422/485 SETUP

SVAT ELECTRONICS

now you can see

In Setup Menu display, press ▲▼ to change the highlighted option to RS-232/422/485, and then press ENTER to call up RS- 232/422/485 Setup as shown.

The RS-232/422/485 Setup allows the administrator to setup RS-232 control port, and RS422 or RS-485 control port. Please refer to the manuals for the connected devices - PTZ cameras – to set these items in RS-232/422/485 Setup.

Following is a brief description for each item and its specific operations:

Device Type PTZ or N/A (Not Available). Press +/- buttons to change the type. Please note that PTZ can only be selected for either RS-232 or RS-485, but not both.

Model – PTZ model of the connected devices. The PTZ models supported include Pelco D protocol Dome, SamSung SCC-641P, etc. Press +/- buttons to change the supported model (or protocol).

Baud Rate – press +/- buttons to change the value. This is a specific value defined by your PTZ camera. Please consult your PTZ manual for the baud rate and protocol.

Data Bit – press +/- buttons to change the value.

Stop Bit – press +/- buttons to change the value.

Parity – (Odd, Even, or None). Press +/- buttons to change the value.

DVR/Camera ID – for PTZ - the device ID for this digital video/audio recorder, and it must not conflict with the other devices connected in the same control port. Press +/- buttons to change the ID. Consult your PTZ manual for instructions on changing the PTZ ID.

The general operations are as below:

▲▼◄►- Press these buttons to select the items.

MODE - Press this button to call up Optional RS-232 Setup screen if it’s built in the DVR. The operations for Optional RS-232 Setup are the same as RS-232/422/485 Setup.

ESC (MENU/ESC) - Press this button to escape from this screen, and return to Setup Menu display. If the Save dialog box is shown, press ENTER to exit and save, ESC (MENU/ESC) to exit without saving.

CLEARVU11

33

 

 

Page 36
Image 36
SVAT Electronics CLEARVU11 instruction manual RS-232/422/485 Setup