SVAT Electronics CLEARVU11 instruction manual Copy

MAIN MENU

SVAT ELECTRONICS

now you can see

Video loss settings are very important for surveillance, since anytime you lose footage, you lose valuable information. The Clearvu11 can perform various tasks when it detects loss of any video, depending on howit is setup. You can adjust the settings for each individual camera.

In Camera Setup, press ENTER to call up Video Loss Setup of the selected camera as shown when the highlighted option is on Settings in the Video Loss row for the camera you wish to setup. Each camera will have its own settings and can be different from the other 3 cameras.

The Video Loss Setup allows the administrator to define how the system responds to the detected video loss for the camera.

The following is a brief description for each item and its specific operations:

Duration – this displays how long (in seconds) the Alarm Out relay and the Buzzer will keep being triggered after video loss is detected for this camera. The Alarm Out relay and the Buzzer will be reset immediately once the camera returns to normal. Press +/- buttons to adjust the value (3 seconds-60 minutes, or discrete).

Pre-record– this allows you to define how long before video loss is detected this camera shall be recorded using the pre-record IPS. Which means there can be up to 10 seconds of video always being recorded before a video loss occurs. The most recent “10 seconds” will always be in the buffer. Press +/- buttons to adjust the value (0-10 seconds, discrete). Please note that the actual pre-record time may be shorter than the value set if the total size of the pre-record pictures exceeds the pre-record buffer size of the system.

Alarm Out – to define which Alarm Output will be triggered when video loss of this camera is detected. Press +/- buttons to select none (N/A) or one of the Alarm Outputs (1-2).

Buzzer – used to activate the internal Buzzer or not when video loss of this camera is detected. Press ENTER or +/- to check/uncheck this item. The default setting is “” - checked.

Log – this selection allows you to create an event log (or not) when the system detects video loss. Press ENTER or +/- to check/uncheck this item. The default setting is “” - checked.

Screen Message – this selection allows you to display the event message on the screen (or not). A message will appear on the scrolling information section at the bottom of the display. Press ENTER or +/- to check/uncheck this item. The default setting is “” - checked.

E-mail– this option will send an event e-mail to a pre-determined email address when video loss is detected. The e-mail will be sent to the predefined receivers at the moment the event is triggered. Press ENTER or +/- to check/ uncheck this item. The default setting is “–” - unchecked. You can set up the pre-determined e-mail in the network setup menu.

The general operations are as below:

•▲▼- Press these buttons to select the items.

•Numeric (CH1-CH4) - Press these buttons to select the camera.

• COPY (	) - Press this button to copy the Video Loss settings of the focus camera to all the following
	cameras. (E.g. focus camera is 1, its Video Loss settings will be copied to those of cameras 2-4.)

•ESC (MENU/ESC) - Press this button to escape from this screen, and return to Camera Setup display. If the Save dialog is shown, press ENTER to exit and save, ESC (MENU/ESC) to exit without saving.

CLEARVU11 19