CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge.
NOTE: If your system fails to boot, press the System ID button for at least five seconds until an error code appears on the LCD. Record the code, then see "Getting Help" on page 165.
Table 1-5. LCD Status Messages
Code | Test | Causes | Corrective Actions |
N/A | SYSTEM NAME A |
| can be defined by the user |
| in the System Setup |
| program. |
| The SYSTEM NAME |
| displays under the |
| following conditions: |
| • The system is powered |
| on. |
| • The power is off and |
| active POST errors are |
| displayed. |
This message is for information only.
You can change the system ID and name in the System Setup program. See "Using the System Setup Program" on
page 41.
E1000 | FAILSAFE, |
| See "Getting Help" on |
| CALL |
| page 165. |
| SUPPORT |
|
|
E1114 | Temp | Ambient system | See "Troubleshooting |
| Ambient | temperature is out of | System Cooling" on |
| acceptable range. | page 138. | |
|
| ||
|
|
|
|
E1116 | Temp Memory | Memory has exceeded | See "Troubleshooting |
|
| acceptable temperature | System Cooling" on |
|
| and has been disabled to | page 138. |
|
| prevent damage to the |
|
|
| components. |
|
|
|
| |
E12nn xx PwrGd | Specified voltage regulator | See "Getting Help" on | |
|
| has failed. | page 165. |
About Your System
23
