CARE OF YOUR OPENER
MAINTENANCE SCHEDULE
Once a Month
LIMIT AND FORCE ADJUSTMENTS:
Weather conditions may cause some minor changes in door operation requiring some re- adjustments, particularly during the first year of operation.
Pages 24 and 25 refer to the limit and force adjustments. Only a screwdriver is required. Follow the instructions carefully.
LIMIT CONTROLS (Left side panel)
9 | 1 | 9 | 1 |
7 | 3 | 7 | 3 |
5 |
|
| 5 |
KG |
|
| KG |
|
|
| |
Open Force | Close Force |
|
•Manually operate door. If it is unbalanced or binding, call a trained door systems technician.
•Check to be sure door opens & closes fully. Adjust limits and/or force if necessary. (See pages 24
and 25.)
•Repeat the safety reverse test. Make any necessary adjustments. (See Adjustment Step 3.)
Twice a Year
•Check chain tension. Disconnect trolley first. Adjust if necessary (See page 7).
FORCE CONTROLS (Right side panel)
Repeat the safety reverse
test (Adjustment Step 3, page 26) after any adjustment of limits or force.
THE REMOTE CONTROL BATTERY
The lithium battery should produce power for up to 5 years. To replace battery, use the visor clip or screwdriver blade to pry open the case as
shown. Insert battery positive side up.
Dispose of old battery properly.
Once a Year
•Oil door rollers, bearings and hinges. The opener does not require additional lubrication. Do not grease the door tracks.
W ARN ING
To prevent possible SERIOUSLY INJURED or DEATH:
•NEVER allow small children near batteries.
•If battery is swallowed, immediately notify doctor.
NOTICE: To comply with FCC and or Industry Canada rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that may cause undesired operation.
Having a Problem?
1.The opener doesn't operate from either the Door Control or the remote control:
• Does the opener have electric power? Plug a lamp
into the outlet. If it doesn't light, check the fuse box or the circuit breaker. (Some outlets are controlled
by a wall switch.)
•Have you disabled all door locks? Review installation instruction warnings on page 7.
•Is there a
any restriction.
•The garage door spring may be broken. Have it replaced.
•Repeated operation may have tripped the overload protector in the motor. Wait 15 minutes and try again.
2.Opener operates from the remote, but not from the Door Control:
•Is the door control lit? If not, reverse the wires. If the opener runs, check for a faulty wire connection
at the door control, a short under the staples, or a broken wire.
•Are the wiring connections correct? Review
Installation Step 6, | page 14. |
3.The door operates from the Door Control, but not from the remote control:
•Is the door push bar flashing? If your model has the Lock feature, make sure it is off.
•Program the opener to match the remote control
code. (Refer to instructions on the motor unit panel.) Repeat with all remotes.
4. The remote control has short range:
•Change the location of the remote control in your car.
•Check to be sure the antenna on the side or back panel of motor unit extends fully downward.
•Some installations may have shorter range due to a metal door, foil backed insulation, or metal garage siding.
5.Opener noise is disturbing in living quarters of home:
•If operational noise is a problem because of proximity of the opener to the living quarters, the Vibration Isolator Kit 41A3263 can be installed. This kit was designed to minimize vibration to the house and is easy to install.
29