![](/images/backgrounds/52313/52313-4021x1.png)
INSTALLATION STEP 12
Connect Door Arm to Trolley
Follow instructions which apply to your door type as illustrated below and on the following page.
SECTIONAL DOORS ONLY
Make sure garage door is fully closed. Pull the emergency release handle to disconnect the outer trolley from the inner trolley. Slide the outer trolley back (away from the door) about 2" (5 cm) as shown in Figures 1, 2 and 3.
Figure 1:
• Fasten straight door arm section to outer trolley with the |
5/16"x1" clevis pin. Secure the connection with a ring |
Inner Trolley
Outer Trolley
Clevis Pin
Ring5/16"x1" Fastener
Door
Bracket
Straight
Door Arm
fastener. |
• Fasten curved section to the door bracket in the same |
way, using the |
Figure 2:
•Bring arm sections together. Find two pairs of holes that line up and join sections. Select holes as far apart as possible to increase door arm rigidity.
Figure 3, Hole alignment alternative:
Figure 1
Clevis Pin
Curved Door Arm
•If holes in curved arm are above holes in straight arm, disconnect straight arm. Cut about 6" (15 cm) from the solid end. Reconnect to trolley with cut end down as shown.
•Bring arm sections together.
•Find two pairs of holes that line up and join with bolts, lock washers and nuts.
Pull the emergency release handle toward the opener at a 45° angle so that the trolley release arm is horizontal. Proceed to Adjustment Step 1, page 23. Trolley will
HARDWARE SHOWN ACTUAL SIZE
Nut
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Clevis Pin |
| Hex Bolt | ||||
Clevis Pin |
|
|
| |||||||
| ||||||||||
5/16"x1" (Trolley) |
|
|
|
| Lock |
| Washers |
| 5/16" |
Nuts | Emergency |
| Release |
| Handle |
Bolts
Door Bracket
Figure 2
Lock Washers
5/16"
Nuts
Bolts
Cut This End
Figure 3
21