Language
Degrees (F/C)
Using the Wall-Mounted Door ControlTHE SMART CONTROL PANEL™
(PROG) Learn Feature

The door control is equipped with a PROG <LEARN> button to assist in learning remote controls to the unit.

Press the push bar to open or close the door. Press again to reverse the door during the closing cycle or to stop the door while it’s opening.

Motion Sensing

On/Off

Prog <Learn>

Hour

Minute

Push

Bar

Press the PROG <LEARN> button once to initiate LEARN mode and the display will show ‘Learn Remote Control - Press Learn Button Again to Confirm.’ Press the PROG <LEARN> button a second time and the display will show ‘Learn Mode - Press Remote Control Button to Learn Remote.’ Press the button of the remote control to be learned and the worklight will blink to confirm the remote control has been learned.

This door control contains a motion sensing detector that

will automatically turn on the light when it

detects a person entering the garage.

 

LIGHT

Light

 

 

LOCK

 

Button

Lock Button

Hour & Minute Feature

HM Press or hold either of these side buttons to increment the hour or minute displayed on the LCD display.

 

Light feature

LIGHT

Press the Light button to turn the opener light on

or off. It will not control the opener lights when the

 

door is in motion. If you turn it on and then activate the

opener, the light will remain on for 4-1/2 minutes. Press

again to turn it off sooner. The 4-1/2 minute interval can be changed to 1-1/2, 2-1/2, or 3-1/2 minutes as follows: Press and hold the Lock button until the light blinks (about 10 seconds). A single blink indicates that the timer is reset to 1-1/2 minutes. Repeat the procedure and the light will blink twice, resetting the timer to 2-1/2 minutes. Repeat again for a 3-1/2 minute interval, etc., up to a maximum of four blinks and 4-1/2 minutes.

When using the opener lights as working lights, we recommend that you first disable the motion sensor. See Automatic Light Feature, below.

Motion Sensing (Automatic Light Feature)

The opener light will turn on automatically when a person enters the garage. When a person walks in front of the door control, the light will come on for five minutes, then shut off. This feature works by detecting body heat.

To disable this feature, push the motion sensing button on the side of the door control.

We recommend that you disable the motion sensor when using the opener lights as working lights. Otherwise, they will turn off automatically if

you are working beyond the sensors range.

Lock feature

Designed to prevent operation of the door from hand-held remote controls. However, the door will open and close from the Door Control, the

LOCK

Outdoor Key Switch and the Keyless Entry Accessories.

To activate, press and hold the Lock button for 2 seconds.

To turn off, press and hold the Lock button again for

2 seconds. The Lock feature will also turn off whenever the “learn” button on the motor unit panel is activated.

(LANG) Language Feature

Press this side button to toggle between the three languages - English, French and Spanish.

Degrees F/C Feature

Press this side button to toggle the temperature units between Fahrenheit and Celsius.

Display Contrast Adjustment

Press and hold the light button then push the hour button to increase the contrast or the minute button to decrease the contrast.

24