IMPORTANT SAFETY INSTRUCTIONS
WARNING
To reduce the risk of SEVERE INJURY or DEATH:
1.This portable luminaire has a polarized plug (one blade is wider than the other) as a feature to reduce the risk of electric shock.
2.This plug will fit in a polarized outlet ONLY one way.
3.If the plug does not fit fully in the outlet, reverse the plug.
4.If it still does not fit, contact a qualified electrician.
5.NEVER use with an extension cord unless plug can be fully inserted.
6 Do not alter the plug.
INSTALLATION STEP 6
Install Remote Light
The remote light is designed to plug directly into a standard 120V outlet.
1.Install the hinge and latch clips. Clips slide in between the metal plate and the plastic housing on each side of the light base (Figure 1).
2.Light should be mounted within 6' (1.8 m) of an electrical outlet and away from any moving parts. Select an appropriate location on the ceiling to mount the light. Mark screw holes on the ceiling by using the light base as a template.
3.If installing remote light on drywall and a ceiling joist can not be located, use wall anchors provided (Figure 2).
NOTE: No pilot hole is required for wall anchors.
4.Install the screws provided leaving 1/8" (3.1 mm) exposed.
5.Determine the length of power cord needed to reach the nearest outlet. Wind any excess cord around cord retainer on the top side of the light base.
6.Install the light base by pushing onto the screws and turning the base clockwise to lock the light in place.
7.Install two light bulbs (100W Maximum - Type A).
8.Install the light lens by hooking one end of the lens over the hinge and pressing up on the other end to latch into place (Figure 3).
NOTE: Light will not operate until the unit is activated.
9. Plug in the light to outlet.
HARDWARE SHOWN ACTUAL SIZE
Light Clip Screw | Screw #6x1" (2) | |||||
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Wall Anchor (2)
CAUTION
To prevent possible OVERHEATING of the light socket,
•DO NOT use short neck or specialty light bulbs.
•DO NOT use halogen bulbs. Use ONLY incandescent or compact fluorescent bulbs
Figure 1
Hinge Clip | Metal | Plastic | |
Plate | Housing | ||
| |||
Light |
|
| |
Base |
|
| |
|
| Latch Clip |
Wall Anchors
Figure 2
Cord
Retainer
Scews
Figure 3
Light
Lens
11