Using the Wall-Mounted

Control Console

THE MOTION DETECTING CONTROL CONSOLE

You may program the remote to open the door with the large button, close it with the middle button, and stop the door’s movement with the third button.

NOTE: If remote is already programmed, you must first

Press the push bar to open or close the door. Press again to reverse the door during the closing cycle or to stop the door while it's opening.

This control console contains a motion detector that will automatically turn on the light when it detects a person entering the garage. This feature can be easily turned off for extended work

light use.

Remote Light feature

Push

Bar

Detector

Switch

Lock

Button Light

Button

erase all codes. See Programming.

1.With the door closed, press and hold the large remote push button.

2.Press and hold the Lock button on the door control

for a minimum of one second

before proceeding to next step.

Open

3. Press and hold the door control

Close

Stop

push bar.

 

4. After the opener lights flash, release all buttons.

When using the remote lights as working lights, we recommend that you first disable the motion sensor. See Automatic Light Feature, following.

Automatic Light Feature: The opener light will turn on automatically when a person enters the garage. When a person walks in front of the control console, the light will come on for five minutes, then shut off. This feature works by detecting body heat and may not work in temperatures around 100˚F (37.7˚C).

To disable this feature, slide the Detector Switch on the right side of the control console down (off).

We recommend that you disable the motion sensor when using the opener lights as working lights. Otherwise, they will turn off automatically if you are working beyond the sensor’s range.

Lock feature (Control console lock only, not power door lock)

Designed to prevent operation of the door from hand-held remote controls. However, the door will open and close from the Control Console, the Outside Key lock and the Keyless Entry Accessories.

To activate, press and hold the Lock button for 2 seconds. The push bar light will flash as long as the Lock feature is on.

To turn off, press and hold the Lock button again for

2 seconds. The push bar light will stop flashing. The Lock feature will also turn off whenever the “Learn” button on the motor unit panel is activated.

Additional features when used with the 3-Button hand-held remote

A) To control the opener lights:

In addition to operating the door, you may program the remote to operate the lights.

1.With the door closed, press and hold a

small remote button that you want to control the light.

2.Press and hold the Light button on the control console.

3.While holding the Light button, press and hold the Lock button on the control console.

4.After the opener lights flash, release all buttons.

B)To operate one door using all three buttons on the hand-held remote:

22