ASSEMBLY STEP 1
Attach the Collar to the Motor Unit
To avoid installation difficulties, do not run the garage door opener until instructed to do so.
To prevent possible SERIOUS INJURY or DEATH, the collar MUST be properly tightened. The door may not reverse correctly or limits may be lost due to collar slip.
• Loosen the collar screws. | |
• | Attach collar to either the left or the right side of the |
| motor unit. Ensure that the collar is seated all the way |
| on motor shaft until stop is reached (Figure 1). |
• | Position the collar so that the screws are facing up |
Figure 1
Collar Screw
(accessible when attached to the torsion bar). |
• Tighten both sides of collar screws equally to secure |
collar to the motor unit |
(Figure 2). |
NOTE: For most installations the screws should be facing up for easy access. Do not tighten set screws until indicated.
ASSEMBLY STEP 2
Attach Mounting Bracket to Motor Unit
•Loosely attach slotted side of mounting bracket to the same side of the motor unit as the collar, using
NOTE: Do not tighten until instructed. Illustrations shown are for left side installation.
HARDWARE SHOWN ACTUAL SIZE
Screw
Set Screw
Collar Screw
Figure 2
RIGHTWRONG
Socket Wrench
6