•Slide a
•Finger tighten the wing nuts.
Figure 5
Wing Nut
Carriage Bolt
Lens
• | Run the wires from both sensors to the opener. | TROUBLESHOOTING THE SAFETY REVERSING | ||
| Use insulated staples to secure wire to wall and | |||
| SENSORS | |||
| ceiling. |
| ||
|
| 1. If the sending eye indicator light does not glow | ||
• | Strip 7/16" (11 mm) of insulation from each set of | |||
steadily after installation, check for: | ||||
| wires. Separate white and white/black wires | |||
| • Electric power to the opener. | |||
| sufficiently to connect to the opener | |||
| • A short in the white or white/black wires. These | |||
| terminals. Twist like colored wires together. Insert | |||
| wires into | can occur at staples, or at opener connections. | ||
| white/black to grey (Figure 6). | • Incorrect wiring between sensors and opener. | ||
ALIGNING THE SAFETY REVERSING SENSORS | • A broken wire. | |||
• Plug in the opener. The indicator lights in both the | 2. If the sending eye indicator light glows steadily but | |||
| sending and receiving eyes will glow steadily if | the receiving eye indicator light doesn’t: | ||
| wiring connections and alignment are correct. | • Check alignment. | ||
The sending eye amber indicator light will glow | • Check for an open wire to the receiving eye. | |||
regardless of alignment or obstruction. If the green | 3. If the receiving eye indicator light is dim, realign | |||
indicator light in the receiving eye is off, dim, or | ||||
either sensor. | ||||
flickering (and the invisible light beam path is not | ||||
NOTE: When the invisible beam path is obstructed | ||||
obstructed), alignment is required. | ||||
or misaligned while the door is closing, the door will | ||||
• | Loosen the sending eye wing nut and readjust, | |||
reverse. If the door is already open, it will not close. | ||||
| aiming directly at the receiving eye. Lock in place. | |||
| The opener lights will blink 10 times. See page 16. | |||
• | Loosen the receiving eye wing nut and adjust | |||
| ||||
| sensor until it receives the sender’s beam. When |
| ||
| the green indicator light glows steadily, tighten the |
| ||
| wing nut. |
| Connect Wire to | |
|
|
| ||
Figure 6 |
| Opener | ||
|
| |||
| Bell Wire | Finished |
| |
| Ceiling |
|
1. | Strip wire 7/16" |
Bell Wire | (11 mm) 7/16" |
| (11 mm) |
2. Twist like colored
wires together
3. Insert into appropriate terminals
Red White Grey
Safety Reversing Sensor
Invisible Light Beam
Protection Area
Safety Reversing Sensor
18