Using the Wall-Mounted Control Console
THE LCD MOTION DETECTING CONTROL CONSOLEThe control console is equipped with a Prog <LEARN> button to assist in learning remote controls to the unit. Press the Prog <LEARN> button once to initiate LEARN mode and the display will show
Press the push bar to open or close the door. Press again to reverse the door during the closing cycle or to stop the door while it's opening.
Automatic Light On/Off
Prog <Learn>
Hour
Minute
Language
Degrees (F/C)
Push Bar
| LIGHT | Light Button |
LOCK |
|
Lock Button
‘Learn Remote Control - Press Learn Button Again to Confirm’. Press the Prog <LEARN> button a second time and the display will show ‘Learn Mode - Press Remote Control Button to Learn Remote.’ Press the button of the remote control to be learned and the worklight will blink to confirm the remote control has been learned.
This door control contains a motion sensing detector that will automatically turn on the light when it detects a person entering the garage.
Light featureLIGHT
Press the Light button to turn the opener light on or off. It will not control the opener lights when the door is in motion. If you turn it on and then activate the opener, the light will remain on for
When using the opener lights as working lights, we recommend that you first disable the motion sensor. See Automatic Light Feature, below.
Lock featureLOCK
Designed to prevent operation of the door from
To activate, press and hold the Lock button for 2 seconds.
To turn off, press and hold the Lock button again for
2 seconds. The Lock feature will also turn off whenever the “learn” button on the motor unit panel is activated.
Motion Sensing (Automatic Light Feature): The opener light will turn on automatically when a person enters the garage. When a person walks in front of the door control, the light will come on for five minutes, then shut off. This feature works by detecting body heat.
To disable this feature, push the motion
sensing button on the side of the door control.
We recommend that you disable the motion sensor when using the opener lights as working lights. Otherwise, they will turn off automatically if you are working beyond the sensors range.
Press or hold either of these side buttons to increment the hour or minute displayed on the LCD display.
(LANG) Language FeaturePress this side button to toggle between the three languages - English, French and Spanish.
Degrees F/C FeaturePress this side button to toggle the temperature units between Fahrenheit and Celsius.
Display Contrast AdjustmentPress and hold the light button then push the hour button to increase the contrast or the minute button to decrease the contrast.
Additional feature when used with theTo control the opener lights:
In addition to operating the door, you may program the remote to operate the lights.
1.With the door closed, press and hold a small remote button that you want to control the light.
2.Press and hold the Light button on the door control.
3.While holding the Light button, press and hold the Lock button on the door control.
4.After the opener lights flash, release all buttons.
27