•Slide a
•Finger tighten the wing nuts.
Recommended Wire Routing1.Using insulated staples, run the wires from both sensors to the rail at the door header (see Figure 6).
2.Run the wires through wire clip at the top of the rails.
NOTE: If your access door is near the garage door, you may choose to install the door control at this time and run the door control wire along the rail with the sensor wires. If you choose this option, follow instructions
Figure 6
Sensor Wire
Figure 5
Wing Nut
Carriage Bolt
Lens
HARDWARE SHOWN ACTUAL SIZE
Carriage Bolt | Wing Nut | Staples | Wire Clip |
|
|
Wire Clip | Bell Wire |
|
Rail
Safety Reversing
SensorInvisible Light Beam
Protection Area
Safety Reversing
Sensor
17