ASSEMBLY STEP 2

Install the Trolley

•Attach the trolley threaded shaft to the trolley with the lock washer and nuts as shown.

•As a temporary stop, insert a screwdriver into the hole in the front end of the T-rail.

•Slide the trolley assembly along the rail to the screwdriver stop.

NOTE: If trolley hits against any nuts on the T-rail, the bolts and nuts were attached from the wrong side and must be repositioned. Review Assembly Step 1.

Outer Nut 5/16"

Trolley

Lock

Inner Nut

Washer

5/16"

5/16"

 

Trolley

Threaded

Shaft

HARDWARE SHOWN ACTUAL SIZE

 

Lock Washer

Nut

Temporary Stop

5/16"

5/16" -18

Screwdriver

 

 

ASSEMBLY STEP 3

Fasten the T-Rail to the Motor Unit

•Place the opener on packing material to protect the cover. For convenience, put a support under the cable pulley bracket.

•Remove the two 5/16"-18x1/2" washered bolts mounted in the top of the motor unit.

•Align the holes in the back section of the T-rail with the holes in the motor unit.

•Fasten the rail with the two washered screws previously removed. Tighten securely. Remember to use only these screws! Any other screws will cause serious damage to the opener.

•Insert a 5/16"-18x7/8" hex bolt into the cover protection bolt hole in the T-rail as shown. Tighten securely with a 5/16" lock washer and nut.

NOTE: This screw prevents trolley over-travel. Keep a 2" minimum between the trolley and this screw when adjusting travel limits (see page 28).

HARDWARE SHOWN ACTUAL SIZE

Hex Bolt

Nut

Lock Washer

5/16"-18x7/8"

5/16"-18

5/16"

CAUTION

To avoid serious damage to opener, ONLY use bolts/fasteners mounted in top of motor unit.

Washered Bolt

 

5/16"-18x1/2"

USE ONLY THIS

Hex Bolt

TYPE AND SIZE

5/16"-18x7/8"

SCREW

Cover

 

Protection

 

Bolt Hole

 

T-Rail

 

(Back Section)

 

Lock Washer

 

5/16"

 

Nut

 

5/16"-18

 

9