
Planning
Identify the type and height of your garage door. Survey | • Look at the garage door where it meets the floor. Any | |
your garage area to see if any of the conditions below | gap between the floor and the bottom of the door must | |
apply to your installation. Additional materials may be | not exceed 1/4" (6 mm). Otherwise, the safety reversal | |
required. You may find it helpful to refer back to this page | system may not work properly. See Adjustment Step 3. | |
and the accompanying illustrations as you proceed with | Floor or door should be repaired. | |
the installation of your opener. | SECTIONAL DOOR INSTALLATIONS | |
Depending on your requirements, there are several | ||
• Do you have a steel, aluminum, fiberglass or glass | ||
installation steps which may call for materials or hardware | ||
panel door? If so, horizontal and vertical reinforcement | ||
not included in the carton. | ||
is required (Installation Step 11). | ||
• Installation Step 1 – Look at the wall or ceiling above | ||
• The opener should be installed above the center of the | ||
the garage door. The header bracket must be securely | ||
door. If there is a torsion spring or center bearing plate | ||
fastened to structural supports. | ||
in the way of the header bracket, it may be installed | ||
• Installation Step 5 – Do you have a finished ceiling in | ||
within 4 feet (1.22 m) to the left or right of the door | ||
your garage? If so, a support bracket and additional | ||
center. See Installation Steps 1 and 11. | ||
fastening hardware may be required. | ||
• If your door is more than 7 feet (2.13 m) high, see rail | ||
• Installation Step 10 – Depending upon garage | ||
extension kits listed on Accessories page. | ||
construction, extension brackets or wood blocks may | ||
| ||
be needed to install sensors. |
| |
• Installation Step 10 – Alternate floor mounting of |
| |
the safety reversing sensor will require hardware not |
| |
provided. |
| |
• Do you have an access door in addition to the garage |
| |
door? If not, Model 7702CB Emergency Key Release is |
| |
required. See Accessories page. |
|
SECTIONAL DOOR INSTALLATION |
| FINISHED CEILING |
|
|
| Support bracket & |
|
| Slack in chain | fastening hardware is |
|
Horizontal and vertical reinforcement | required. See page 15. |
| |
tension is normal |
| ||
is needed for lightweight garage doors |
|
| |
when garage |
|
| |
(fiberglass, steel, aluminum, door with |
|
| |
glass panels, etc.). See page 23 for details. | door is closed. |
|
|
|
|
| |
Header Wall |
|
|
|
| Extension Spring | Motor Unit | |
| OR |
| |
|
|
| |
| Torsion Spring |
|
|
|
| ||
| Door Control |
|
— — | Vertical | |
— | Centerline of | |
| ||
— — | Garage Door | |
Safety | ||
— | ||
Reversing | ||
| ||
— — | Sensor | |
Gap between floor and bottom of | ||
| ||
| door must not exceed 1/4" (6 mm). |
Safety Reversing Sensor
Access Door
Header | CLOSED POSITION | ||
Bracket Trolley |
|
| |
Stop Bolt | Trolley | ||
|
| ||
Garage |
|
|
|
Door |
|
| Chain |
Spring |
|
| |
|
| Emergency | |
|
|
| |
| Straight | Release | |
| Door |
| Rope |
| Arm |
| & Handle |
Header | Curved |
Wall | Door Arm |
| Door |
Garage | Bracket |
Door |
|
4