®
Model CLLAD Security✚® Plug-In Light Control
Modèle N° CLLACD Security✚® Commande d’eclairage enfichable Modelo CLLAD Security✚® Control de luz de enchufe
Light Control Actuator
Commutateur de commande d’éclairage
Actuador de control de luz
Antenna
Antenne
Antena
Learn Button
Bouton LEARN
Botón "APRENDER" (Learn)Learn Indicator Light
Voyant indicateur d’apprentissage
Luz indicadora de aprendizaje
WARNING
To prevent possible SERIOUS INJURY or DEATH from electrocution or fire, the light control is ONLY for indoor use.
AVERTISSEMENT
Pour éviter les risques de BLESSURE GRAVE ou de MORT causés par l’électrocution ou l’incendie, la commande d’éclairage doit être utilisée UNIQUEMENT pour l’intérieur.
ADVERTENCIA
Para prevenir LESIONES GRAVES O LA MUERTE posibles de electrocución o incendio, el control de luz es para uso interior
SOLAMENTE.
OWNER’S INSTRUCTIONS
The
The Light Control can be operated by a 900D Chamberlain series portable remote control and/or a keyless entry.
The
•Plug the light control into a 120Vac polarized outlet. The plug contacts are designed for polarized outlets only.
•Press and release the “learn” button on the
•Within 30 seconds, press and hold the button on the
•Release the remote control push button.
Code setting is now complete. | Select a | |
push button | ||
|
The remote control push button must be held down until the receiver indicator light flashes for the light control to learn the remote control's code.
ENGLISH
ERASING CODES
If the receiver LEARN button is pressed and held until the yellow indicator light alongside goes out (in about 6 seconds), all memorized codes will be erased.
OPERATING INSTRUCTIONS
If two or more
•First, plug the lamp into a wall outlet and turn it ON.
•With the lamp still in the ON position, plug it into polarized outlet on the light control. Plug the Light Control into a 120Vac polarized outlet. The bulb will not light.
•TO TEST: Press and release the light control actuator. The light should turn ON. Press the remote control push button. The light should turn OFF.
If the remote control does not activate the light, check to be sure:
•You are pressing the remote control push button selected to operate the light control.
•The remote control battery has power. Refer to the remote control instructions for battery changing information.
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RATING
Resistive Load . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10 Amps
Motor Load . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1/3 HP
Incandescent Lamp . . . . . . . . . . . . . . . . . . . . . . . . .600 Watts