Preparing the Cabinet for Use – Concessionaire Dispensers
Parts List
■Faucet Standard.
■Faucet Head Assembly
■Caster Set.
■Black Connector Hose 3⁄16” x 3’.
■5⁄16” Air Hose.
■Spanner Wrench.
■Bag of Miscellaneous Parts.
Tools Required
■#2 Phillips Screwdriver.
■Spanner Wrench (included).
■#10 Crescent Wrench.
■9/16” Allen Wrench.
■3/8” Nut driver.
■Power driver.
Uncrating and Inspection
Remove all crating material before operating. Carefully inspect cabinet for hidden damage. If damage is discovered, file your claim immediately with the transportation company. Perlick is
not responsible for damage in transit.
Installing Casters
IMPORTANT: Attach casters to the cabinet bot- tom so that caster is centered over cabinet seam.
Use supplied 1/4”- 20 x 3/4” hex head
Plumbing
Connect drain tube from drainer into dump tank.
Electrical
The cabinet must be connected to a separately fused power source (see electrical specification plate) and grounded in accordance with National and Local Electrical Codes. Caution: Do not attempt to operate the equipment on any other power source than that listed on the Electrical Specification plate.
Installing the Faucet and
Dispensing Head
Before you begin: Wash dispensing head and fau- cet. Flush beer, dispensing head and faucet lines with fresh water.
■Apply RTV around the base of the dispensing head to seal it to the top. Align the dispensing head over the five holes on the cabinet top and use the five stainless steel
Phillips pan head stainless steel machine screws to secure standard to cabinet top. Wipe off excess RTV to complete the seal.
■Attach faucet to standard using spanner wrench to tighten coupling. Attach faucet handle to faucet.
■Insert flexible plastic air hose six to seven inches into bottom of faucet standard. Secure hose with tie wrap (supplied).
CASTER MOUNTING |
|
|
PLATE MUST |
| CABINET |
STRADDLE SEAM |
| |
| DRAIN TuBE | ACCESS |
| HOLE | |
| FROM | |
|
| |
| DRAINER |
|
| DuMP TANK |
|
COMPRESSOR | CO2 TANK |
|
ACCESS DOOR |
| |
HOUSING |
| |
|
|
| CHAIN FOR | |
SCREWS | SECuRING | |
CO2 TANK | ||
|
DRY | REMOVABLE | CO2 TANK |
DuMP TANK | ||
STORAGE |
| (Must Be Secured |
COMPARTMENT |
| |
| When Moving | |
|
| |
CENTER CASTERS |
| Cabinet) |
|
| |
REQUIRED ON DC4KP |
|
|
(4 KEG CONCESSIONAIRE) CASTER MOUNTING |
|
|
PLATE MUST |
|
|
STRADDLE SEAM |
|
|
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.
3 | Form No. Z2283 |
Rev. 06.14.10 |
