Chamberlain PD432DM 1/2 HP Carton Inventory

Carton Inventory

Your garage door opener is packaged in one carton which contains the motor unit and all parts illustrated below. Accessories will depend on the model purchased. If anything is missing, carefully check the packing material.

PARTS MAY BE STUCK IN THE FOAM. Hardware for assembly and installation is shown on the next page. Save the carton and packing material until installation and adjustment is complete.

	Remote Control
	Visor Clip
	Sprocket Coupling
LOCK
LIGHT	SECURITY✚®
	SECURITY✚®
Multi-Function Door	1-Button Remote Control (2)
Multi-Function Door
Control Panel	Rail Support Braces (4)
	Rail Support Braces (4)

Motor Unit with 2 Light Lenses

2 Conductor Bell Wire

White & White/Red

Rail Assembly

Straight Door

Arm Section

Trolley

Header/Rail Brackets

ONLY

MOUNT

CEILING

UP

Header Bracket

Hanging Brackets

The Protector System®

(2) Safety Reversing Sensors

(1 Sending Eye and 1 Receiving Eye) with 2-Conductor White & White/Black Bell Wire attached

Curved Door

Arm Section

Door Bracket

Safety

Labels and

Literature

Safety Reversing

Sensor Bracket (2)

6

Contents

Page Introduction Assembly Installation Adjustment Operation Preparing your garage door Tools needed Planning Planning (Continued) Carton Inventory Hardware Inventory Assemble the Rail Assemble the Rail (continued) Fasten the Rail to the Motor Unit and Install the Trolley Attach the Rail Brackets Determine the Header Bracket Location Install the Header Bracket Attach the Rail to the Header Bracket Install The Protector System ® INSTALLING THE BRACKETS Garage door track installation (preferred): Wall installation (Figure 2 & 3): Floor installation (Figure 4): MOUNTING AND WIRING THE SAFETY SENSORS Recommended Wire Routing Position the Opener Hang the Opener Install the Door Control Attach the Emergency Release Rope and Handle Electrical Requirements Complete the Safety Reversing Sensor Installation Fasten the Door Bracket ONE-PIECEDOORS Metal Doors: Connect Door Arm to Trolley ALL ONE-PIECEDOORS 1. Assemble the door arm, Figure 5: 2.Adjustment procedures, Figure 6: •Closed door adjustment: decrease DOWN travel limit 3.Connect the door arm to the trolley: Adjust the UP and DOWN Travel Limits Adjust the Force Test the Safety Reversal System Test The Protector System® Using Your Garage Door Opener Using the Wall-MountedDoor Control THE MULTI-FUNCTIONDOOR CONTROL Light feature DISCONNECT THE TROLLEY: Lock feature LIMIT AND FORCE ADJUSTMENTS: THE REMOTE CONTROL BATTERY MAINTENANCE SCHEDULE Every Month Every Year 2. My remotes will not activate the door: 3.My door reverses for no apparent reason: 5.My lights will not turn off when door is open: Diagnostic Chart 1 FLASH 2 FLASHES 3 FLASHES 4 FLASHES To Add or Reprogram a Hand-heldRemote Control To Erase All Codes From Motor Unit Memory *3-ButtonRemotes (315 MHz) To Add, Reprogram or Change a Keyless Entry PIN Rail Assembly Parts KEY NO DESCRIPTION Installation Parts Motor Unit Assembly Parts 953D 3-ButtonSECURITY✚® Remote Control : 935CB 940D OUR LARGE SERVICE ORGANIZATION SPANS AMERICA INSTALLATION AND SERVICE INFORMATION IS AS NEAR AS YOUR TELEPHONE SIMPLY DIAL OUR TOLL FREE NUMBER: