Installation Step 11
Fasten Door Bracket
Follow instructions which apply to your door type as illustrated below or on page 21.
CAUTION
To prevent damage to steel, aluminum, fiberglass or glass panel doors, always reinforce the inside of the door both vertically and horizontally with angle iron.
A horizontal brace should be long enough to be secured to 2 vertical supports. A vertical brace should cover the height of the top panel.
The illustration shows one piece of angle iron as the horizontal brace. For the vertical brace, 2 pieces of angle iron are used to create a
SECTIONAL Door Installation Procedure
Header
Bracket
Door
Bracket 
Location
Vertical
Guideline
•Center the door bracket on the previously marked vertical guideline used for the header bracket installation. Note the correct UP placement as stamped inside the bracket.
•Position the bracket on the face of the door within the following limits:
A)The top edge of the bracket
B)The top edge of the bracket directly below any structural support across the top of the door.
•Mark and drill 5/16" left and right fastening holes. Secure the bracket as shown in Figure 1 if there is vertical reinforcement.
If your installation doesn't require vertical reinforcement but does need top and bottom fastening holes for the door bracket, fasten as shown in Figure 2.
Horizontal and vertical reinforcement |
|
is needed for lightweight garage doors |
|
(fiberglass, aluminum, steel, | Figure 1 |
doors with glass panel, etc). | |
| |
Vertical |
|
Reinforcement | |
| Vertical |
| Guideline |
Carriage Bolt | UP |
| |
| |
Door |
|
Bracket |
|
Lock |
|
Washer |
|
5/16" | Nut |
| |
Inside Edge | Figure 2 |
| |
of Door or |
|
Reinforcement Board |
|
| UP |
Door Bracket
Hardware Shown Actual Size
Nut | Lock Washer 5/16" |
Carriage Bolt
20