Read the Safety Instructions on page 8. They also apply to doors without tracks.
•Close the door and mark the inside vertical centerline of your garage door. Extend the line onto the header wall above door.
If headroom clearance is minimal, you can install the header bracket on the ceiling. See page 10.
•If you need to install the header bracket on a 2x4 (on wall or ceiling), use lag screws (not supplied) to securely fasten the 2x4 to structural supports as shown.
Unfinished
Header Wall | Vertical | Ceiling |
| ||
|
| |
| Centerline | 2x4 |
|
|
Structural
Supports
2x4
Vertical
Centerline of
Garage Door
OPTIONAL CEILING MOUNT
FOR HEADER BRACKET
Header Wall
Highest Point
of Travel
Door
Jamb | Distance |
| |
Hardware |
|
Door
Header | Highest Point |
Wall | of Travel |
Distance
Pivot
jamb hardware
•Open your door to the highest point of travel as shown. Measure the distance from the top of the door to the floor. Subtract the actual height of the door. Add 8" to the remainder. (See Example).
•Close the door and draw an intersecting horizontal line on the header wall at the determined height.
If the total number of inches exceeds the height available in your garage, use the maximum height possible, or refer to page 10 for ceiling installation.
pivot hardware
EXAMPLE |
|
|
Distance from top of door |
|
|
(at highest point of travel) to floor........................... | 92" | |
Actual height of door ............................................. | ||
|
|
|
Remainder................................................................ | 4" | |
Add......................................................................... |
| +8" |
Bracket height on header wall.............................. | =12" | |
(Measure UP from top of CLOSED door.) |
|
|
Proceed to Step 2, page 10.
9