Receiver and Remote Control Programming

NOTICE: To comply with FCC/IC rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER

SERVICEABLE PARTS.

Your garage door opener receiver and remote control transmitter have been set at the factory to a matching code. The door will activate when the remote control push button is pressed.

Your "Smart" garage door opener will operate with:

•up to four "Smart" remote control transmitters (with green indicator lights),

•a Keyless Entry System, and

•code switch transmitters with red indicator lights.

Below are instructions for programming your opener to match any additional remotes you may purchase. See available accessories on page 34.

To Add A Remote

1.

Press and hold the remote push button. See

 

Figure 1.

2.

Then press and release the "Smart" button on the

WARNING

Children operating or playing with a garage door opener can injure themselves or others. The garage door could close and cause serious injury or death. Do not allow children to operate the Door Control or remote control transmitter(s).

A moving garage door could injure or kill someone under it. Activate the opener only when you can see the door clearly, it is free of obstructions, and is properly adjusted.

Figure 1

Single Function Remote Control

Battery

Indicator Light

back panel of the opener in Figure 2. The opener

lights on the panel will flash once.

3. Release the remote push button.

Now the opener will operate when the remote control push button is pressed.

If you release the remote control push button before the opener lights flash, the opener will not accept the code.

To Erase All Remote Control Codes

Figure 2

Push Button

Garage Door Opener (With "Smart" Button)

•Press and hold the "Smart" button on the opener panel until the indicator light turns off (about 6 seconds). All the codes the opener has learned will be erased.

1

2

3

•To reprogram, repeat Steps 1 - 3 for each remote control in use.

9

1

9

1

7

3

7

3

5

 

 

5

KGKG

"Smart" Indicator

Button Light

END PANEL

Code programming instructions are also located on the opener panel.

29