A D J U S T M E N T

SEQUENCED ACCESS MANAGEMENT SYSTEM (SAMS)

The Sequenced Access Management System or SAMS allows the customer more control when managing vehicular entrances to areas such as apartment complexes, businesses and gated communities. The basic concept of the system is that traffic is controlled by two gates installed in tandem, a fast moving gate such as a barrier gate operator and a slower moving more secure or ornamental gate such as a single or pair of slide/swing gate operator. The design of this gate system balances the demands of speed during high traffic periods with security during low traffic periods. Barrier gates typically have the fastest open times of the many gate operator types and the slide or swing gates allow you to effectively seal off the perimeter of the complex you are planning to secure.

NOTE: Connect all entry devices to the slide or swing gate. If using a device, such as a 7-day timer, to latch the slide or swing gate open during high traffic times, connect the device’s N/O relay output to the control board’s Interrupt Loop input. Once the device activates the Interrupt Loop input, the next vehicle to access the SAMS system will lock the gate in the open position until the device deactivates. When the device deactivates, the timer to close will automatically close and secure the gate.

SAMS OPERATION

1.When an authorized vehicle accesses the gate system, the SAM system responds by first opening the gate farthest from the vehicle, the swing or slide gate.

2.Once the swing or slide gate is open, the barrier gate begins its open cycle.

TERMINAL BLOCK

BG770 BARRIER GATE

INTERRUPT LOOP INPUT

AUXILIARY LIMIT SWITCH

TB5

N/0

TB8

COM

SAMS RELAY AT J5

TERMINAL STRIP

N/0

1 (OPEN)

COM

3 (COMMON)

 

TRAFFIC

STREET

 

Open

Loop

Hold

 

 

 

SAMS Conduit

Second

3.Once the barrier is open the vehicle may pass through the SAM system. At this point you have two options in how you would like to initiate the SAM systems closure. You may chose to:

a.Use a timer to close system to automatically close the barrier gate after a preset amount of time or

b.Use a loop system to close the barrier gate after the vehicle has passed through the SAM system.

4.Once the barrier gate is closed the slide or swing gate will activate its internal timer to close and begin closing.

5.If another authorized vehicle accesses the SAM system before the slide or swing begins to close the barrier will open and allow the vehicle to pass through the SAM system.

6.If another authorized vehicle accesses the SAM system during the slide or swing gates closing cycle the SAM system will reopen the slide or swing gate. Once the slide or swing gate reaches the open position the barrier will then open to allow the vehicle to pass through the SAM system.

7.If no other authorized vehicles access the SAM system the swing or slide gate will close followed by the barrier.

SAMS WIRING

1.Install conduit between the BG770 and the SW420 for SAMS control wiring.

2.Run a 4-conductor cable in the conduit between the BG770 SW420.

3.Locate the SAMS relay terminals (J5) on the control board in the SW420 and locate the auxiliary limit switch in the BG770.

4.Attach a wire from the SAMS relay terminal (J5) on the control board to terminal 1 on the BG770 terminal strip.

5.Attach a wire from the SAMS relay terminal (J5) on the control board to terminal 3 on the BG770 barrier gates terminal strip.

6.Attach a wire from terminal J1-5 on the control board to the common (COM) on the auxiliary limit switch in the barrier gate.

7.Attach a wire from terminal J1-8 on the control board to the normally open (NO) on the auxiliary limit switch.

8.Test for correct functionality of the SAM system.

Master

Shadow

Loop

 

 

Loop

 

Safety

 

COMPLEX

 

 

 

 

OR

 

 

PARKING LOT

20