Chamberlain TCR2 DIP SWITCH SETTINGS & POWER CONNECTIONS, NOTE:, Figure, Figure, Figure, Setting DIP Switch, Power Supply and Relay out Connections

DIP SWITCH SETTINGS & POWER CONNECTIONS

Setting DIP Switch

The TriCode® Receiver DIP switch CH1 is factory set OFF (1-10) and CH2 is factory set ON (1-10).

Locate the 10 position DIP switch. If this is a new installation using TriCode® transmitters, randomly set switches matching those of the transmitter. Never use factory settings. If receiver is used with Linear/Delta 3TM, Multi-CodeTMor StanleyTM transmitters, match the receiver DIP switch to the above transmitters. Some transmitters may use toggle switches and it may be difficult to determine on & off. If so, try reversing the setting on the TriCode® DIP switch (Figures 4 and 5).

NOTE: In 'LINEAR/DELTA-3TM' mode (8-bits system) the last 2 bits (DIP #9 & 10) settings are ignored. They can be left in either ‘ON’ or ‘OFF’ settings.

Figure 4					Multi/ StanleyTM
					(1 Thru 10)
			Linear/ Delta-3TM
				(1 Thru 8)
	1	2	3		4	5	6	7	8	9	10
DIP	O
	N
Switch	O
	F
	F

Power Supply and Relay out Connections

There are six wires exiting the housing (Figure 6):

RED & BLACK - POWER INPUT

BROWN & BLUE - CHANNEL 1 RELAY OUTPUT WHITE & GREEN - CHANNEL 2 RELAY OUTPUT

Figure 6	Red
	Power
	Supply
	12V/24V
	Black
	Brown
Relay
Output	Blue
Ch1
	White
Relay
Output	Green
Ch2

DIP

Switches

Channel 2 DIP Switch	O 1	2	3	4	5	6	7	8	9	10
	N

Figure 5

Channel 1 DIP Switch	O 1	2	3	4	5	6	7	8	9	10
	N

O 1		2	3	4		5	6	7	8	9	10
N
O	1	2			4						10
N

For installation and service information please

call our toll free number:

1-800-528-2806

or contact us through the web at

www.chamberlaingroup.com

	© 2007, The Chamberlain Group, Inc.
01-17468D	All Rights Reserved