Upper back panel | Char-Broil 463210011 guide

3

This step requires two people to lift and position grill head onto cart. Carefully lower the grill head onto the cart, aligning slots at bottom of grill head with posts on cart side panels. Make sure the regulator hose is hanging inside the cart.

Regulator hose

Left side panel

Grill head

Right side panel

4

On back of grill, place upper back panel between side panels. Secure upper back panel, in lower holes, using one 1/4-20x1½”screw, 7mm lock washer and 7mm flat washer on each side.

Upper back panel

1/4-20x1½” screw

7mm lock washer

7mm flat washer

14

Image 14

Char-Broil 463210011 manual Upper back panel

Contents

Estimated assembly time 30 minutes Date Purchased Table of Contents This Grill is for Outdoor USE only Installation Safety Precautions California Proposition LP Cylinder Filling USE and CareLP Liquefied Petroleum Gas LP Cylinder Leak Test For your safetyUseDo not household cleaning agents. Damage to gas Turn all grill control knobs to OFF Leak Testing Valves, Hose and RegulatorConnection, do not use this regulator SDo not lean over grill while lighting For Safe Use of Your Grill and to Avoid Serious InjuryIgnitor Lighting Open lid during lighting Sideburner Match Lighting General Grill CleaningSideburner Ignitor Lighting Burner Flame Check Very Important Burner tubes must reengage valve Cleaning the Burner AssemblyStoring Your Grill Turn gas OFF at control knobs and LP cylinder Limited Warranty Items Manufacturer will not PAY for Parts List Key Qty Description Parts Diagram Assembly Front Upper back panel Temperature gauge stem Bracket Back of main control panel Grease tray opening Left rail Right rail Wire Flame tamers Grease tray Cylinder screw at rear of cart Troubleshooting Emergencies Possible Cause Prevention/Solution AUTO-CLEAN Troubleshooting Electronic Ignition SectionPage Warranty Registration Department Box Columbus, GA