Assembly | Char-Broil 463210510 specification

ASSEMBLY

1

Place legs as shown.NOTE:Left leg assembly has large holes on ends of legs. Attach center brace, left front				and left rear
leg with 1/4-20x1/2" screws,7mm Flat Washer and 7mm Lock Washer on each side.
Attach upper brace, left leg assembly which			was assembled previously with 1/4-20x1/2" screws,7mm	Flat Washer
and	7mm Lock Washer on each	side. Note orientation of Upper Braces as shown in image.
The	assembly method of right leg	assembly	is similar to left leg assembly.

		Upper Brace,	Upper Brace,
	Qty: 12	Upper Brace,	Right Cart
		Left Cart	Right Cart
		Left Cart
	1/4-20x1/2"
	Machine Screw

Qty: 12

7mm Flat Washer

	Center Brace	Right Rear Leg
		Right Front Leg
Qty: 12	Left Rear Leg
7mm Lock Washer
	Left	Front Leg

2

Place bottom shelf with cut out hole for LP cylinder next to legs with axle holes.

Attach to right and left leg assemblies with 1/4-20x1/2" screws, 7mm Flat Washer and 7mm Lock Washer on each side.

Qty: 4

1/4-20x1/2"

Machine Screw

Qty: 4

7mm Flat Washer

Qty: 4

7mm Lock Washer

Right	Leg	Assembly

Left	Leg	Assembly

Bottom	Shelf
Bottom
	Front

Rear

17

Image 17

Char-Broil 463210510 manual Assembly

Contents

Date Purchased Estimated assembly time 35-40 minutes This Grill is for Outdoor USE only Table of Contents California Proposition Installation Safety Precautions First Time Use TemperatureLava Rock / Briquettes Pre-Heating Your Grill Direct Cooking Food SafetyIndirect Cooking Rotisserie Cooking Usda Recommended Safe Minimum Internal Temperatures General Cleaning Why Clean?Routine Care Storing Your Grill LP Cylinder Filling USE and CareLP Liquefied Petroleum Gas Do not use household cleaning agents. Damage to gas For your safetyLP Cylinder Leak Test Nipple has to be centered into the LP cylinder valve Turn all grill control knobs to OFF Leak Testing Valves, Hose and RegulatorConnection, do not use this regulator Ignitor Lighting For Safe Use of Your Grill and to Avoid Serious InjurySDo not lean over grill while lighting Open lid during lighting Sideburner Ignitor Lighting General Grill CleaningSideburner Match Lighting Burner Flame Check Storing Your Grill Cleaning the Burner AssemblyTurn gas OFF at control knobs and LP cylinder Very Important Burner tubes must reengage valve Disclaimer of Implied Warranties and Limitation of Remedies Limited Warranty Not Pictured Parts ListKey Qty Description Parts Diagram Assembly Front panel Upper Qty #10-24x1/2 Machine Screw Qty Tank Retainer ,Wire Form Hitch Pin Qty 20x1/2 Machine Screw Page Sideburner Valve Ten t Page Hose Emergencies Possible Cause Prevention/Solution Troubleshooting AUTO-CLEAN Section Troubleshooting Electronic IgnitionPage Page Warranty Registration Department Box Columbus, GA