We suggest three ways to clean the burner tubes. Use the one easiest for you.
(A)Bend a stiff wire (a light weight coat hanger works well) into a small hook. Run the hook through each burner venturi tube several times.
(B)Use a narrow bottle brush with a flexible handle (do not use a brass wire brush), run the brush through each burner venturi tube several times.
(C)Wear eye protection: Use an air hose to force air into the burner tube and out the burner ports. Check each port to make sure air comes out each hole.
10.Wire brush entire outer surface of burner to remove food residue and dirt.
11.Clean any blocked ports with a stiff wire such as an open paper clip.
12.Check burner for damage, due to normal wear and corrosion some holes may become enlarged. If any large cracks or holes are found replace burner.
VERY IMPORTANT: Burner venturi must be attached with orifice holder properly. see illustration below.
Correct
engagement
NOTE:
Reinstall
Screws
13.After cleaning put the burner back into the firebox and attach the electrode wire onto the electrode connector under the burner.
14.Place burner into position and reinstall the hitch pin.
15.Under the firebox, attach the orifice holder with the venturi tube. with the screws previous removed.
16.Replace the grease pan, tank heat shield, greasy tray, radiator plate, and cooking grates.
10
