18 First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.
Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on fascia. Attach using two
Note: Use left and right holes on fascia to attach valve bracket
Screws and Washers removed from valve bracket
Note: Use upper and lower holes on fascia to attach bezel
Control knob | |
|
4mm lock washer
Sideburner fascia
Valve stem
Sideburner valve bracket
Side burner bezel
Note: Make sure set the bezel with longer slot at the top
198a Insert sideburner burner into left shelf. The stud on bottom of burner fits into rear small hole in sideburner drip pan on shelf, shown A. Secure burner to sideburner drip pan with one Wing nut, shown B. Under sideburner shelf, attach sideburner ignitor wire to electrode. Make sure burner tube engages sideburner valve, shown C.
B
Wing nut
C
tube burner
electrode
ignitor wire
sideburner drip pan
sideburner burner
valve
sideburner drip pan
A
26
