14
Release the cap and nut from electronic ignition module. Attach electronic ignition module to the cart right side panel with the nut and cap, shown A.
Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition Module.Total (4) connections.
Connect the two wires(A and B) from the switch wiring harness into the back of the Electronic Ignition Module. Total (2) connections.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown as A,B.
A
Electronic |
|
ignition module | Right side panel |
Nut Cap
1 
2
A
3
4
B
Wire
15
Install flame tamers by sliding one end of each flame tamer into slots at front of firebox and resting opposite end on pins in back of firebox.
Note: Some parts omitted for clarity of illustration
Front of firebox
Flame tamers
Back of firebox |
Pin |
20
