Char-Broil 463270911 manual Rear

12

Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and facing the front. Secure using two 1/4-20x1½”screws, 7mm lock washers, and 7mm flat washers on each side.

NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED IN THE MOST DOWNWARD POSITION WHEN ASSEMBLED TO CART.

Door

Hinge Pin

	7mm flat	7mm lock	1/4-20x1½”
Front brace	washer	washer	screw

13

Inside of cart, insert rear shield tab into left slot on upper of lower back panel. Insert left and right grease tray rails into slots beneath grease tray opening in upper back panel, shown A. Attach front shield tabs under front brace and attach right and left rails under front brace with three #8x3/8” self-tapping screws, shown B.

Front

	Tank heat shield
Rear	*This side UP

Tank heat shield

B

Note: some parts omitted for clarity of illustration

Front Brace

A

Cart lower back panel

#8x3/8”

self-tapping screw

Right rail

Left rail

Left rail

Right rail

Tank heat shield

Grease tray opening

19