Grill head Regulator hose | Char-Broil 463270911 guide

3

Place lower back panel between side panels at rear of bottom shelf. Secure lower back panel to side panels using four 1/4-20x1/2”screws, 7mm lock washers, and 7mm flat washers on each side.

Lower back panel

1/4-20x1/2” screw

7mm lock washer

7mm flat washer

4

This step requires two people to lift and position grill head onto cart. Carefully lower the grill head onto the cart, aligning slots at bottom of grill head with posts on cart side panels. Make sure the regulator hose is hanging outside the cart. Grill head must face open side of cart.

Grill head

Regulator hose

14

Image 14

Char-Broil 463270911 manual Grill head Regulator hose

Contents

Estimated assembly time 30 minutes Date Purchased Table of Contents This Grill is for Outdoor USE only Installation Safety Precautions California Proposition LP Cylinder Filling USE and CareLP Liquefied Petroleum Gas LP Cylinder Leak Test For your safetyUseDo not household cleaning agents. Damage to gas Turn all grill control knobs to OFF Leak Testing Valves, Hose and RegulatorConnection, do not use this regulator SDo not lean over grill while lighting For Safe Use of Your Grill and to Avoid Serious InjuryIgnitor Lighting Open lid during lighting Sideburner Match Lighting General Grill CleaningSideburner Ignitor Lighting Burner Flame Check Very Important Burner tubes must reengage valve Cleaning the Burner AssemblyStoring Your Grill Turn gas OFF at control knobs and LP cylinder Limited Warranty Items Manufacturer will not PAY for Parts List Key Qty Description Parts Diagram Assembly Front Grill head Regulator hose Upper back panel Now you may fully tighten lower screws on upper back panel Holes on fascia to Attach valve bracket Electrode Rear Wire Flame tamers Grease tray Cylinder screw at rear of cart Troubleshooting Emergencies Possible Cause Prevention/Solution AUTO-CLEAN Troubleshooting Electronic Ignition Section Warranty Registration Department Box Columbus, GA