Char-Broil 466247310 manual Screws and Washers removed from valve bracket

8

Remove the four screws and washers factory attached to the Auto Clean valve bracket. Position Auto Clean valve bracket beneath right side shelf fascia so that valve stem comes through larger center hole in fascia. Align the four holes on valve bracket with the four holes on fascia. Secure using screws and washers that were removed from bracket, shown A.

Place the blank bezel over valve stem on front side of the fascia. Align small holes on bezel with the holes on fascia. Attach using two #8-32x1/4”screws and 4mm lock washers. Press control knob on to valve stem, shown B.

A

Screws and Washers removed from valve bracket

Auto Clean valve bracket

valve stem

B

#8-32x1/4” screw 4mm lock washer

knob

Bezel(blank)

18