Section B Con’t.

B3

WARNING

Bezels must be replaced one at a time. Removing more than one bezel at a time may cause misalignment of manifold.

Pull the Tube Burner Control Knob off of Valve Stem.

Remove two Screws and two Washers that secure Bezel to the Control Panel. Save removed Bezel for converting back to LP Tank Gas.

Install new Natural Gas Bezel provided with Kit (see illustration below) in place of old Bezel onto Control Panel, and secure using previously removed Screws and Washers. Assure proper alignment with control knob before fully tightening. Note: New bezels will change the rotation for the control knob to properly control ignition and flames for your grill.

Press Control Knob back onto Valve Stem. Make adjustments needed to Bezel for free movement of Control Knob

Repeat for each Bezel.

OFF

Bezels

Lock Washers

Hi

Valve

Stem

Low

Screws

Med

Large Bezel

B4

Tube Burner Control Knobs

Reinstall Tube Burners

Insert Tube Burners into Firebox Burner holes over Valves with Ignitor Assembly downward, making sure Tube Burner engages Valve properly. See diagram below.

Secure Tube Burners to Burner Brackets with previously removed Hitch Pins. Replace Carryover tubes and secure with Hitch Pins previously removed. Reference illustration B1.

Correct

Incorrect

burner-to-valve

burner-to-valve

engagement

engagement

 

Tube Burner

9

Page 9
Image 9
Char-Broil 7116572 manual Section B Con’t, Bezels Lock Washers Valve Stem, Screws