Soot Door
In Side or Rear
Of Chimney
Fig 8. Vertical Register Plate With Bricked Up Fireplace
Alternative
Soot Door
Positions
Register Plate
With Soot Door
Blanking Plate
Blanking Plate
Back of the Stove
Clamping Plate with fold horizontal
Clamping plate finishes
flush with inside face of firebox top and bottom.
Alternative
Soot Door
Positions
Register Plate
With Soot Door
Fig 9. Horizontal Register Plate
With Rear Flue Connection
Alternative
Soot Door
Positions
Register Plate
With Soot Door
Fig 10. Horizontal Register Plate With Top Flue Connection
act as a low limit thermostat This should be wired into the mains supply to the pump so that if the gravity return temperature drops below 45º C then the pump will cut out. This will help to prevent condensation forming
Fig 11. Horizontal Register Plate
With Optional Vertical
Rear Flue Connector
on the boiler faces and will thereby increase the life of the boiler. It will also ensure that priority is given to the domestic hot water. These thermostats are available from ourselves if you are unable to obtain them locally.
CONNECTIONS TO
FLUES
There are several ways of connecting the stove to the flue. These are illustrated in figures 8 to 10.
If the optional vertical rear flue connector is used then the chimney may be swept through the appliance.
Horizontal lengths of flue must be kept to a minimum and should not be more than 150mm (6 inches) long. The sealing face of the flue collar must be coated with fire cement before fixing to the body of the stove using the two screws provided. The blanking plate must be removed, sealed with fire cement and refitted, care being taken to ensure that the fold on the clamping plate is in line with the lugs on the firebox as shown in Fig. 12. Ensure the clamping plate does not prevent the throat plate from seating correctly. All flue connections must be well sealed.
SOOT DOORS
It is possible to pass a 16 inch diameter sweeps brush through the appliance but in most back outlet installations it will be necessary to have a soot door to enable the chimney to be swept. This may either be in the actual brickwork of the
Page 7
Seal Blanking Plate with fire cement
Fig. 12. Flue Blanking Plate.
chimney or in the register
plate. Various types and positions of soot doors are shown in figures 8 to 10.
THERMOSTAT
Before lighting the fire check the cold setting distance of the thermostat.
Remove the cover plate on the left hand side of the stove to give access to the thermostat. With the control knob at the maximum setting the flap should be 18 mm from the air inlet as shown in Fig. 13. To adjust the distance slacken the locking nut and adjust as necessary. When set correctly
18mm
Locking Nut
Thermostat Flap
Fig. 13. Thermostat Setting
Country 14B 09/03
