ASSEMBLY
Fit the side panels, hood and top grid onto the appliance. Instructions for this are enclosed with the panel pack.
Replace any internal parts previously removed.
PRE LIGHTING
CHECK
Before initial lighting check the following points:
1.The bottom grate bars must all be fitted and should move freely and easily when the riddling mechanism is operated.
2.The plates round the sides and
| Flaunching |
| Take Flue Pipe |
| Up To Narrowest |
| Part Of Chimney. |
| 150° Elbow |
| Part No. 010/AV12 |
| Vermiculite |
150° | Infill |
Fig. 10. Typical Installation | |
back of the grate must be in position and sitting correctly.
3.The throat plate must be fitted in the roof of the appliance.
COMMISSIONING
On completion of the installation and after allowing a suitable period of time for the fire cement and mortar to dry out, the fire should be lit and checked to ensure that smoke and fumes are taken from the appliance up the chimney and emitted safely. Also check all joints and seals.
The central heating pump should be adjusted to give the correct water flow against the circuit resistance and the system should be correctly balanced.
On completion of the installation and commissioning please leave the operating instructions with the customer and advise on the use of the fire and any controls on the system.
FREESTANDING KIT
A freestanding kit is available. Details of dimensions and outputs are available on request.
18mm
LockingNut
Thermostat Flap
Fig. 11. Thermostat Setting
Page 10
LA30iB 3.99
