TO RESTORE ALL SETTI NGS TO T HEIR FACTORY DEFAULT S:
Warning: This will erase all user settings and revert the fixture back to the original factory defaults!
1)Under the
2)“Select: Ok”.
3)Press the <ENTER> button
Operation
Stand-Alone Mode (Sound-Active, Auto Mode):
This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto Mode.
1)Set the fixture to the desired standalone mode by selecting it in the onboard menu.
2)Press <MENU/ESC> until you reach the “2- Run” option. Press <ENTER>.
3)Select the desired standalone program using the <UP> and/or <DOWN> buttons. Press <ENTER>.
Master/Slave Mode (Master Sound, Master Auto):
This mode will allow you to link up to 32 units together, without a controller.
1)Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the units. For longer cable runs we suggest a terminator at the last fixture. For more information about terminators, see page 12.
2)Choose a unit to function as the Master. Adjust the options in the display of the master unit to one of the 3 Master Standalone modes: Auto, Sound, & Econtr. The unit must be the first unit in line. Then simply daisy chain the units together using DMX cable.
3)Set the “Run” to “Slave” on the slave units, and they will react the same as the Master.
DMX Mode
This mode allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with DMX, please read the DMX Primer on Page 30.
1)Press <MENU/ESC> until you reach the
2)Press <ENTER>.
3)Adjust your starting DMX address by using the <UP> and/or <DOWN> buttons..
4)Press <MENU/ESC> until you reach the “2- Run”.
5)Press <ENTER>.
6)Using the <UP> and/or <DOWN> buttons, “Select: Slave”.
7)Press <ENTER> button.
Intimidator™ Spot 150 User Manual | 18 | 6/19/2009 9:08 AM |
